Sanyo EDUCATION PROJECTOR PLC-XE31LMP PLC-XE31LMP Manual Do Utilizador

Before calling your dealer or service center for assistance, check the items below once again.

–Make sure you have properly connected the projector to peripheral equipment as described on pp. 16-18. 
–Make sure all equipment is connected to AC outlet and the power is turned on.
–When you operate the projector with a computer and it does not project an image, restart the computer.  

– Solutions

– Plug the power cord of the projector into the AC outlet.
– See if the POWER indicator lights red.
– Wait 90-120 seconds after the projector is turned off when turning 

the projector back on.  The projector can be turned on after the 
POWER indicator turns red.  (See on p. 20.)

– Check the WARNING indicator.  If the WARNING indicator lights red,

the projector cannot be turned on.  (See on p. 53.)

– Check the projection lamp.  (See p. 56.)

– Adjust focus of the projector.  (See p. 23.)
– Provide proper distance between the projector and the projection 

screen.  (See p. 14.)

– Check the projection lens to see if it needs cleaning.  (See p. 55.)
– Moving the projector from a cool to a warm place may result in 

moisture condensation on the projection lens.  In such cases, leave 
the projector off and wait until condensation evaporates.

– Check the connection between your computer or video equipment 

and the projector.  (See pp. 16–18)

– See if the input signal is correctly output from your computer.  Some

laptop computers may need to change the setting for monitor output
when connecting to a projector.  See your computer’s instruction 
manual for the setting. 

– It takes about 30 seconds to display an image after turning on the 

projector.See if the selected system is corresponding with your 
computer or video equipment.  (See pp. 27 and 37)

– Select correct input source once again through menu operation.

(See pp. 26 ,35 and 36)

– Make sure the temperature is not out of the specified Operating 

Temperature (

41 ˚F ~ 95 ˚F (5 ˚C ~ 35 ˚C)) 

.

– Check the Ceiling / Rear function.  (See p. 45.)

– Check the Ceiling function.  (See p. 45.)

–  Check audio cable connection from audio input source.
–  Adjust the audio source.
–  Press the Volume+ button.  (See p. 24.)
–  Press the Mute button.  (See p. 24.)