Digitus Internet Broadband Router with 4 Port N-Way Switch DN-11004-O Manual Do Utilizador

 

 

11

    Before you start to connect your router to any network device, make sure you get the following values 

from your ISP. You will need those values to setup the Router and configure you networked PCs to 

accept the IP address the Router chooses to assign them. 

• 

PPPoE User Name and Password or Fixed Internet IP Address assigned by your local ISP 

• 

Your Subnet Mask 

• 

Your Default Gateway 

• 

Your Primary DNS IP address 

You are supposed to have all those information mentioned above from your ISP. If not, contact your 

ISP and they will be able to supply all the information you need. 

 

    Follow the steps listed below to install your Router when you have all the information mentioned 

above on hand. 

   

This should include your PCs, Cable or DSL modem and the Router. 

Step 2.

Connecting Computers: Connect computers directly to the Router on ports 1~4 on the   

rear panel. If you have more than 4 computers need to be connected, connect a hub or a switch (using its 
uplink port) and connect additional computers to that device. 

 

Connecting a Cable Modem or DSL Modem: Connect your Cable or DSL modem to the   

WAN port on the rear panel. 

 Connecting a Printer: If you have a printer that you want to share between computers, 

connect it to the Printer port using a standard

 USB Cable. 

 Power: Plug the power cord into the power jack. And power on computers. 

 

 

 

 

 

 

 

 

         

 

 

 

Internet

PC

PC

Notebook

Router

USB Printer

Cable/DSL
   Modem

Switch/Hub