Philips Cube micro sound system DCM109 DCM109/79 Manual Do Utilizador
Códigos do produto
DCM109/79
12
Note
If you are not going to use the remote control
•
for a long time, remove the batteries.
Do not use old and new or different types of
•
batteries in combination.
Batteries contain chemical substances, so they
•
should be disposed of properly.
Plug & Play
When you connect the unit to the power
supply for the first time, or no radio station
is stored in this unit, Plug and Play mode is
activated to store all available radio stations
automatically.
1
Connect the unit to the power supply.
[AUTO INSTALL - PRESS PLAY,
»
STOP CANCEL] (auto install - press
the PLAY button; to cancel, press
) displays.
2
Press
on the main unit to start
installation.
[AUTO] (auto) displays.
»
[PROG] (program) flashes.
»
The unit automatically store radio
»
stations with sufficient signal strength.
3
When all the available radio stations are
stored, the first preset radio station is
broadcast automatically.
Tip
If no key is pressed during Plug and Play
•
mode, the system goes to Standby mode
after timeout of 5 times. To go to installation
again, press and hold
for 3 seconds under
Standby mode.
Toexit Plug and Play installation mode
1
press source keys or on the remote
control.
The system switches to the designated
»
source mode or standby mode.
4 Get started
Caution
Use of controls or adjustments or
•
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
rear of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Prepare the remote control
Caution
Risk of explosion! Keep batteries away from
•
heat, sunshine or fire. Never discard batteries
in fire.
1
Open the battery compartment.
2
Insert 2 AAA batteries (not supplied)
with correct polarity (+/-) as indicated.
3
Close the battery compartment.
3
1
2
EN
DCM109_79_UM_V1.0.indb 12
2010-5-7 9:47:44