Audix ADX10FLP Folheto

The microphone shall be of the condenser type with a modular threaded capsule. The microphone 
shall  be  available  in  a  cardioid  polar  pattern  and  shall  have  a  3’  or  8’  cable  (depending  on  model) 
terminating in a mini-XLR female connector. The microphone shall have a sensitivity of 4.5 mV /Pa and 
a nominal impedance of 800 ohms at 1 kHz. The microphone shall have a maximum SPL level of ≥120 
dB and shall be machined out of brass with a length of 25 mm and a capsule diameter of 10 mm. The 
microphone shall be the Audix ADX10 FL.

  

The ADX10 FL is designed to plug directly into the bodypack of the RAD360 wireless system. To 

use the ADX10 FL as a wired mic, the model that includes the phantom power supply (ADX10 FLP) 

will be needed.   

The ADX10 FL and ADX10 FLP are low impedance microphones and should be plugged into a 

“mic level” input on your console, mixer or recording device. The ADX10 FLP requires phantom 

power and will NOT operate without phantom power voltage (minimum of  9 - 48 Volts) which is 

available on most professional mic preamps and mixing devices. If phantom power is not available 

on your equipment, use the Audix APS 911, a supplied accessory with the ADX10 FLP model that 

allows for battery operation. Avoid plugging or unplugging the microphone from a PA system unless 

the channel is muted or the system volume is turned down. Failure to do so may result in a loud 

“popping” noise which could seriously damage the speakers in the PA system.

With the “crown” of the flute detached, simply place the “O-ring” portion of the ADX10-FLP mic clip 

at the end of the “head joint” and reattach the crown to the head joint.

The APS 911 phantom/battery power supply: The mini-XLRf connector at the end of the ADX10-

FL plugs directly into the mini-XLRm connector on the APS-911 power adapter. Next, plug a 

standard XLR-XLR microphone cable to complete the connection from the APS-911 to the mixing 

board. The APS 911 has the option to be used in phantom power mode or battery mode. If there is 

no phantom power available on the mixing console or equipment being used to amplify your signal,  

use the battery mode to power up the mic. If further reduction of bass frequencies or plosives is 

needed, the APS 911 is equipped with a base roll-off filter.  

ADX10 FL/ADX10 FLP

SERVICE AND WARRANTY:

This microphone is under warranty for a period of 3 years from 
any and all manufacturing defects. Should your microphone 
fail in any way, please contact the Audix Service department 
at  503-682-6933.  A  Return  Authorization  number  is  required 
before returning any products

.

CARE AND MAINTENANCE:

The ADX10-FL & ADX10-FLP are manufactured to exacting specs with 
roadworthy construction. However, the capsule is highly sensitive and should 
be handled with care. Avoid extreme temperatures and be sure to store your 
microphone in the pouch provided when not in use. Moisture of any kind can 
adversely affect the sound and performance of your microphone. 

***All specifications subject to change without notice.

www.audixusa.com 

503-682-6933 Fax: 503-682-7114 

Audix Corporation 9400 SW Barber St. Wilsonville, OR 97070

Please Check all that apply:

    Male      Female
Age: 

 

Occupation:  

Primary Instruments:       Product to be used for:    

    18 or Under 

   Musician   

   Vocal 

 

        Pro live sound

    19-25   

   Producer   

   Guitar / Bass 

        Pro recording

    26-35   

   Sound Eng. 

   Drums   

        Home recording

    36-45   

   Radio/TV   

   Keyboard  

        Rehearsal

    46-55    

   Production 

   Brass 

 

        Installation

    55 +  

 

   Other _______ 

   Woodwinds 

        School

 

 

 

 

   Strings   

        House of Worship

How did you hear about Audix?  

 

   Other ___________          Other ___________

   Magazine Ad            Online Ad  

   On-line Store            Friend                               Do you own other Audix Products?      Yes      No

   Salesman                 Other __________            Model(s) ________________________________

 

 

 

                  Have you visited the Audix website?     Yes       No  

Please register your product online at www.audixusa.com or mail this form to:

Audix Microphones P.O. Box 4010 Wilsonville, OR 97070

Name:________________________________ Model:___________________

Company:_____________________________ Serial Number:_____________

Address:______________________________ Store:____________________

City:_________________________________  Store Location:_____________

Prov./State:___________ Zip:_____________ Purchase Date:_____________

Phone: (     )___________________________ Signature:_________________

Email:________________________________ Date:____________________ 

1.1