Netgear DUALBAND WLAN WNDAP360 N300 AP WNDAP360-PES Manual Do Utilizador
Códigos do produto
WNDAP360-PES
Introduction
13
ProSafe Dual Band Wireless-N Access Point WNDAP360
The rear panel functions of the ProSafe Dual Band Wireless-N Access Point WNDAP360 are
described in the following list:
described in the following list:
1.
Reverse SMA connector for an optional 2.4-GHz antenna.
2.
Factory default Reset button. Using a sharp object, press and hold this button for about
5 seconds to reset the wireless access point to factory defaults settings. All configuration
settings are lost, and the default password is restored. For more information, see
5 seconds to reset the wireless access point to factory defaults settings. All configuration
settings are lost, and the default password is restored. For more information, see
3.
Console port for connecting to an optional console terminal. The port has an RJ-45
connector and supports the following settings: 9600 K default baud rate, (8) data bits, no (N)
parity bit, and one (1) stop bit.
connector and supports the following settings: 9600 K default baud rate, (8) data bits, no (N)
parity bit, and one (1) stop bit.
4.
10/100/1000BASE-T Gigabit Ethernet (RJ-45) port with Auto Uplink (Auto MDI-X) with
IEEE 802.3af Power over Ethernet (PoE) support for connection to a switch or router.
IEEE 802.3af Power over Ethernet (PoE) support for connection to a switch or router.
5.
Cable security lock receptacle for an optional lock.
6.
Power socket for a 12 VDC, 1A power adapter.
7.
Reverse SMA connector for an optional 2.4-GHz antenna.
Bottom Panel with Product Label
The product label on the bottom of the wireless access point’s enclosure displays factory
default settings, regulatory compliance, and other information:
default settings, regulatory compliance, and other information:
Figure 3.