Lecroy WSXS-SPIBUS TD WSXS-SPIBUS TD trigger and decoder extension Compatible with LeCroy WaveSurfer® oscilloscopes. WSXS-SPIBUS TD Manual Do Utilizador
Códigos do produto
WSXS-SPIBUS TD
Operator's Manual
919586 RevA
183
Using the USB2 Option
Using the USB2 Option Overview
The USB 2.0 decode option shows the packet level of the USB 2.0, USB 1.1, and USB 1.0 standards, consisting of
Token, Data, and Status packets.
Token, Data, and Status packets.
PLEASE NOTE THE FOLLOWING:
Currently, USB2 Trigger functionality is available exclusively for the WaveRunner 6 Zi oscilloscope.
Ask your local LeCroy representative for more information about any Serial Data Debug Solution Protocols
or Toolkits using the Contact LeCroy for Support (on page 199) topic.
or Toolkits using the Contact LeCroy for Support (on page 199) topic.
USB2 Decode Setup Detail
For general information about using controls shown on the main Serial Decode dialog, refer to Accessing The D
and TD Supported Protocol Toolsets (on page 13).
and TD Supported Protocol Toolsets (on page 13).
USB2D
ECODER AND
E
XPORTER
R
IGHT
-H
AND
D
IALOGS
Access the Serial Decode dialog by touching Analysis → Serial Decode on the menu bar.
Touch the corresponding Setup... button for your decode. The Decode Setup... along with the USB2Decoder
right-hand dialog is shown.
right-hand dialog is shown.
USB2Decoder Right-Hand Dialog
The USB2Decoder right-hand dialog provides detailed controls and setup conditions as follows:
Configure the Probe Selection control based on whether you're using One Differential Probe, Two Single
Ended Probes or One Single Ended Probe.
Ended Probes or One Single Ended Probe.
The number of Source Selectors on the Decode Setup dialog change to accommodate the chosen Probe
Selection in the following manner:
Selection in the following manner:
One Differential Probe
With One Differential Probe selected, a single data positive, data negative Source Selector is shown on
the main Decode Setup... dialog.
the main Decode Setup... dialog.