Yageo Electrolytic capacitor snap-in 10 mm 220 µF 400 V 20 % (Ø x H) 30 mm x 30 mm LG400M0220BPF-3030 1 pc(s) LG400M0220BPF-3030 Ficha De Dados

Códigos do produto

LG400M0220BPF-3030

1-1 Precautions in Using Aluminum Electrolytic Capacitors

Please note the following recommendations when use capacitors:

10. Keep the following clearance between the vent of the capacitor

and the case of the appliance . Do not

block the operation of the

vent , unless otherwise described on the

catalogues or product

specifications . The narrower clearance may adversely

affect the

vent operation and result in an explosion of the capacitor .

Case diameter

Clearance

6.3 to 16 mm

2 mm minimum

18 to 35 mm

3 mm minimum

40 mm & up

5 mm minimum

Fig.1-1

-size electrolytic capacitors , nothing abnormal will be occurred if

and insulation sleeve of electrolytic capacitors . In the case of small

dipping is performed at less than 260ºC for less than 10 seconds .

merely standard values .

Before using the products , please read the notes in this catalogue

carefully for proper use .

notice for product improvement . Therefore , please confirm the

specification before ordering products .

The general characteristics , reliability data , etc ., described in this

catalogue should not be construed as guaranteed values , they are

9. Do not apply excessive force to the lead wires or terminals .

If excessive force is applied to the lead wires and terminals , they

Attention

may be broken or their connections on the internal elements may

be affected . (For strength of terminals , please refer to JIS C5102

and C5141 . )

The description in this catalogue is subject to change without prior

7. Be careful of temperature and time when soldering .

care must be taken that the soldering temperature is not too high

and that the dipping time is not too long .

Otherwise , there will be adverse effect on the electrical characteristics

When soldering a printed circuit board with various components ,

8. Cleaning circuit boards after soldering .

Halogenated hydrocarbon cleaning solvents are not recommended

for use in cleaning capacitors supplied with exposed end seals .

Where cleaning with a halogenated solvent is desired , capacitors

should be ordered with an Epoxy-coated end seal .

6. When capacitors have been left unused for long time , use them only

after due voltage treatments . Long storage of capacitors tends to

rise their leakage current levels . In such cases , be sure to provide

temperature range . Use at room temperature will ensure a longer

life .

5. The electrolytic capacitor is not suitable for circuits which are

charged and discharged repeatedly .

Use the electrolytic capacitor at current value within the permissible

ripple range . If the ripple exceeds the specified value , request

the necessary voltage treatment before use .

If used in circuits which are charged and discharged repeatedly , the

capacitance value may drop or the capacitor may be damaged .

Please consult our engineering department for assistance in these

applications .

capacitors for high ripple current applications .

Use the electrolytic capacitors according to the specified operation

4. Ascertain the operation temperature range .

1. Electrolytic capacitors for DC applications require polarization .

Confirm the polarity before use . The circuit life may be shortened

or the capacitor may be damaged if insert in reversed polarity . For

use on circuits whose polarity is occasionally reversed , or whose

polarity is unknown , use non-polar capacitors . Also note that the

electrolytic capacitors cannot be used for AC applications .

3. Do not allow excessive ripple current passing.

2. Do not apply a voltage exceeding the capacitor's voltage rating.

If a voltage exceeding the capacitor's voltage rating is applied , the

capacitor may be damaged by increased leakage current . When

using the capacitor with AC voltage do not exceed the rated voltage .

•