Perfectpro MyTUBE MYTUBE R Manual Do Utilizador

1.  Insert batteries and place the radio on a flat surface.

2.  Plug the AC/DC power adaptor into the AC socket if desired.

3.  Carefully extend the antenna located at the back of the radio. Adjust the antenna so it is vertically extending above the radio.

4.  The radio will start up and the display will show “FM RADIO” for a few seconds. Then the radio will automatically perform an

auto scan of the FM waveband.

5.  When the scan is completed, the 10 strongest FM stations will be stored as presets. The radio will switch to standby; the display  

will show “Goodbye” for a few seconds.

1.  Press the On/Off button to turn on the radio.

2.  If this is the first time to switch on, the radio will be in FM RADIO mode and the station in preset 1 will be played. If the radio has

been used before, the last listened station will be played.

3.  To seek station, press the Tuning Down or Tuning Up button. The scan stops automatically when it finds a station of sufficient

 strength.

4.  After a few seconds, the display will update and show station name if RDS information is being received.

5.  To find other stations, press the Tuning Down or Tuning Up button again.

6.  To seek station in an opposite direction, press the Tuning Up button (to scan from low frequency to high frequency) or press

 the 

Tuning Down button (to scan from high frequency to low frequency).

7.  When the waveband end is reached, the radio will recommence tuning from the opposite waveband end.

1.  Press the On/Off button to turn on the radio.

2.  Press the SOURCE button to switch to FM RADIO mode.

3.  Press the Tuning Down or Tuning Up button to reach the required FM frequency. The radio will change the frequency in steps

of 50 kHz.