Ehmann Room thermostat Flush mount 24 h mode 5 up to 30 °C D 6060c0100 Manual Do Utilizador
Códigos do produto
6060c0100
Room temperature controller
The thermostat is suitable for controlling the temperature in domestic and business premises with a common degree of pollution.
It is intended for installation in outlet boxes in accordance with DIN 49073.
It is intended for installation in outlet boxes in accordance with DIN 49073.
Technical data:
Sensing element:
Bi-metal Type 1C
Breaking capacity at 250V~
Break contact:
Heating contact
Break contact:
Heating contact
10(4)A
Changeover switch:
Heating contact-Cooling contact:
Heating contact-Cooling contact:
5(2)A
Degree of protection:
IP30
Switching temperature difference:
approx. 0.5K
Temperature set-back:
approx. 4K
Temperature range:
+ 5...+30°C
After appropriate installation:
class II protection
Permissible humidity:
max. 95% rH
Non-condensing
Place of installation:
To ensure proper functioning, the thermostats should be installed at a place where they can be operated free from draughts and
the effects of extraneous heat. Avoid installation to external walls.
the effects of extraneous heat. Avoid installation to external walls.
Assembly and connection:
- Use screw driver to lever off button (1)
- Release screw (2)
- Take off casing cover (3)
- Remove intermediate frame (4) and frame (5)
- Release screw (2)
- Take off casing cover (3)
- Remove intermediate frame (4) and frame (5)
In the case of multiple frames, position the controller
at the lowest position!
at the lowest position!
- Connect device in accordance with circuit diagrams
(skinning length 8mm)
- Always mount supporting ring (6) with controller (7) onto
the wallpaper
- Use screws to attach device to flush socket.
- Close casing in reverse order
- Close casing in reverse order
Note:
To protect the thermostat from dirt during construction measures,
the supplied construction protection cover (transparent PS cover)
should be used.
the supplied construction protection cover (transparent PS cover)
should be used.
Limiting the setting range:
- Take off pin (1)
- Turn red stop (2) for maximum temperature and
- blue stop (3) for minimum temperature
- Reinsert locking pin (1).
- Turn red stop (2) for maximum temperature and
- blue stop (3) for minimum temperature
- Reinsert locking pin (1).
Technical changes reserved.
Safety instructions:
Work on the 230 V mains may only be performed by a specialist under consideration of the valid regulations
(e.g. IEC or VDE).
All types of work may only be performed when the mains voltage is switched off.
If the device is opened or tampered with, the warranty will expire.
(e.g. IEC or VDE).
All types of work may only be performed when the mains voltage is switched off.
If the device is opened or tampered with, the warranty will expire.
19.335.00 GB/ Rev. 05-10
Do not install
at these spots
5
7