Cisco Wireless-G Exterior Access Point WAP2000E-G5 Manual Do Utilizador
Códigos do produto
WAP2000E-G5
PRODUCT DATA
BUSINESS SERIES
Features
10BASE-T/100 BASE-TX
Ethernet Port, Autosensing
half/full duplex & MDI/MDI-X
Ethernet Port, Autosensing
half/full duplex & MDI/MDI-X
Full backwards compatibility
with 802.11b
with 802.11b
Easy installation and
configuration Web Interface
configuration Web Interface
Dual images for resilient
firmware upgrades
firmware upgrades
Supports WEP, WPA-PSK,
WPA2-PSK, WPA-ENT, WPA2-
ENT authentication (802.11i
ready)
WPA2-PSK, WPA-ENT, WPA2-
ENT authentication (802.11i
ready)
SMA detachable Dipole
antennae with 1x2 MIMO to
increase coverage
antennae with 1x2 MIMO to
increase coverage
Supports Power over
Ethernet (PoE) or external
DC power
Ethernet (PoE) or external
DC power
Supports 4 BSSID and
802.1Q VLAN to SSID
mapping
802.1Q VLAN to SSID
mapping
Supports SNMP and
intuitive Web-based
interface
intuitive Web-based
interface
WMM wireless QoS support
- upgradeable to 802.11e
- upgradeable to 802.11e
Supports wireless roaming
based on 802.11F (IAPP)
based on 802.11F (IAPP)
Supports AP, Bridge Mode
and Repeater mode
and Repeater mode
Supports wireless client
isolation
isolation
Metal casing
3 year limited warranty
Linksys One Ready - Simple,
one-step automated
installation and initial
configuration
one-step automated
installation and initial
configuration
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Wireless-G Access Point with Power over Ethernet
Specifications
Model
WAP2000
Standards
IEEE802.11g, IEEE802.11b, IEEE802.3, IEEE802.3u,
IEEE802.3af (Power over Ethernet), 802.1p (QoS priority), 802.1Q (VLAN),
802.1X (Security Authentication), 802.11i - Ready (Security WPA2),
802.11e - Ready (Wireless QoS), 802.11F (Wireless Roaming)
Ports
10BASE-T/100BASE-TX Ethernet, 12VDC Power
Buttons
Reset
Cabling Type
UTP CAT 5
LEDs
Power, PoE, Wireless, Ethernet
Operating System
Linux
Setup/Config
WebUI
Built-In Web UI for Easy Browser-Based Configuration (HTTP/HTTPS)
Management
SNMP Version
SNMP Version 1, 2c, 3
Event Logging
E-Mail Notification
Remote Syslog
Web F/W upgrade
Firmware Upgradeable Through Web-Browser
Diags: Flash, etc.
Diags: Flash, RAM, LAN, WLAN
DHCP
DHCP Client
Operating Modes
Access Point
Access Point Mode, Point-to-Point Bridge Mode,
Point-to-Multipoint Bridge Mode, Repeater Mode
Wireless
Spec/Modulation
Radio and Modulation Type: 802.11b/DSSS, 11g/OFDM
Channels
Operating Channels: 11 North America, 13 Most of Europe
(ETSI and Japan)
# of Internal Ant.
None
# of External Ant.
2 (Omnidirectional) 3dBi SMA Detachable
Transmit Power
Transmit Power (Adjustable) @ Normal Temp Range:
11b - 18 dBm; 11g - 16 dBm
Antenna Gain in dBi
3
Receiver Sensitivity
11.g: 54Mbps@ -72dBm, 11.b: 11Mbps@ -85dBM
Security
WEP/WPA/WPA2
WEP 64bit/128bit, WPA-PSK, WPA2-PSK, WPA-ENT, WPA2-ENT
Access Control
Wireless Connection Control: MAC-Based
SSID Broadcast
SSID Broadcast Enable/Disable
802.1X
IEEE 802.1X Support
Wireless Client Isolation
Wireless Client Devices can be Isolated from Each Other Either Within an
SSID or Between Two SSIDs
Quality of Service
QoS
4 Queues
WMM Wireless Priority
General
Wireless Roaming based on IAPP
Load Balancing
Auto-Channel Selection