Conrad Energy NiMH-BatteryAA-Single cell1.2 V / Solder lug: Yes 206648 Ficha De Dados
Códigos do produto
206648
Product Specification
Model No
:VGPAA2300
Document Number ERS-2017-P-Y
Edition: A
Page 3 of 4
Test
Unit
Remarks
Internal impedance(Ri)
m
≤30
Upon fully charge (1KHZ)
Unit cell
High Rate Discharge
minute
≥108
Standard Charge , 1hr rest
(0.5C)
before discharge
High Rate Discharge
minute
≥48
Standard Charge , 1hr rest
(1C)
before discharge
Overcharge
N/A
No leakage nor
230mA(0.1C) charge for 48 hrs
explosion
charge Retention
mAh
≥1380(60%)
Standard charge
Storage: 28 days at RT or
7 days at 45
Storage: 28 days at RT or
7 days at 45
℃
Standard discharge
IEC Cycles Test
Cycle
>500
IEC 61951-2 (2003)
(see note 3)
Accelerated Cycls Life
Cycle
≥100
Charge: 1150mA(0.5C)
Cycling charging
Discharge:1150mA(0.5C) to
cut off condition:
1.0V/cell
-
△V = 0~5V/cell
End of life:60% of
or time cut off =
nominal capacity
105% of input
capacity
capacity
Leakage
N/A
No leakage nor
Fully charged at 1150mA
deformation
(0.5C), stand for 14 days
Short Circuit
N/A
Leakage &
After standard charge.
deformation may
short circuit the cell at
occur, but no
20+/-5
℃ until the cell
explosion is
temperature returns to
allowed
ambient temperature.
(The resistance of the inter-
connecting circuitry
shall not exceed 0.1 ohm.)
(The resistance of the inter-
connecting circuitry
shall not exceed 0.1 ohm.)
Vibration
N/A
change of voltage
Charge at 0.1C for 16hrs
Unit cell
Resistancs
△V﹤0.02V
and then leave for 24hrs
change of internal
check battery before after
impedance
vibration
△R﹤5m
Amplitude: 1.5mm
Vibration: 3000CPM
(any direction for 60mins)
Vibration: 3000CPM
(any direction for 60mins)
Impact
N/A
change of voltage
Charge at 0.1C for 16hrs
Unit cell
Resistance
△V﹤0.02V
and then leave for 24hrs
change of internal
check battery before/ after
impedance
drop
△R﹤5m
Height: 50cm
Thickness of the wooden
board: 30mm
Direction is not specified
Test for 3 times
Thickness of the wooden
board: 30mm
Direction is not specified
Test for 3 times
4. CONFIGURATIONS,DIMENSIONS AND MARKINGS
Please refer to the related drawing.
Please refer to the related drawing.
5. EXTERNAL APPEARANCE
The cell / battery shall be free from cracks,scars, breakage, rust, discoloration, leakage and deformation
Manufacture reserves the right to alter or amend the design, model and specification without prior notice
Specification
Condition