Jeti 5-channel receiver 2.4 GHz with Connector system JR 80001226 Manual Do Utilizador

Códigos do produto
80001226
Página de 31
EN
3.  After removal of the case disconnect the antenna 
cable from the connector of the original module
4.  Open  up  the  hole  for  the  originally  used  push 
button in the case to 6 mm dia.
5.  Connect the antenna cable to the TA transmitter 
module connector and put everything back into the 
case.
6.  Close the case again by means of the two screws, 
shift the antenna in place and plug-in the module back 
into the transmitter.
7.  Place a new sticker DUPLEX EX, as delivered with 
the TA module, over the original module sticker.
Now the module must be paired with the receiver, see 
ELECTROSTATIC  SENSITIVE  DEVICE
OBSERVE HANDLING PRECAUTIONS
Putting into operation
Pairing with the receiver and performance verification
Any receiver and transmitter module takes advantage of digital transfer for communication purposes, in order to 
enable direct address communication between the equipment it is necessary to apply the so called pairing between 
them. The description of a transmitter module is given by its unique address which after pairing to the receiver 
ensures, that the receiver will accept only data from this definite transmitter. There may be paired as many receivers as 
you like with the transmitter module, but a receiver can be paired to one transmitter only.
Install the receiver into your model. If the equipment is switched on first time we explicitly recommend to ensure that 
no detrimental effects on health or property may occur due to unexpected receiver output conditions (for instance 
badly adjusted mixers, reversed outputs etc.).
Activate receiver pairing by means of the shorting plug (BIND PLUG), which is a part of the receiver. 
below.  Be  careful  when  switching  on  the  transmitter  Aurora  9,  the  module  is  not  switched  on  as  long  as  the 
transmitter is not in transmitting mode. You will recognize the switch-on state of the module when the red LED starts 
blinking. The blinking red LED on the module indicates communication between module and transmitter. At the 
transmitter working in Duplex mode moreover a green LED will turn on.
Disassembled module Aurora
UFL connector
Transmitter modules