Spektrum DX18 SPM18000 Manual Do Utilizador

SPEKTRUM DX18 • TRANSMITTER INSTRUCTION MANUAL

Use the Sailplane Type Screen to select wing and tail types to 
match your sailplane model. Diagrams and setup names show 
on the transmitter screen to show the available setups.   
Refer to community.spektrumrc.com for more information about 
new DX18 AirWare updates to support these options.

   1 Servo
   2 Aileron*
   2 Aileron 1 Flap*

   2 Aileron 2 Flap*
   4 Aileron 2 Flap*

   Normal
   V-Tail A**
   V-Tail B**

   Inhibit
   Assign to a Switch (optional)

NOTICE: Refer to your sailplane manual for recommended control throws.

Always do a Control Test of your model with the transmitter after programming to 

make sure your model responds as desired. 

Camber Preset is only available when 2 or 4 aileron wing type is 
selected in Sailplane Type. The Camber Preset function enables 
you to program the ailerons, fl aps, wing tips and elevator for a 
specifi c position in each Flight Mode.
If fl ight modes are not active, only one preset position is 
available and it is always active.
The Camber Preset Speed enables the control surfaces to 
transition over a period of time, up to 30 seconds, when you 
change fl ight modes.

Move the fl ight mode switch to the desired position to change 
the Camber Preset values. 
  

Camber System is only available when 2 or 4 aileron wing 
type is selected in Sailplane Type. The Camber System allows 
in-fl ight camber adjustment and is also used as the braking 
system, often referred to as Crow or Butterfl y. The Camber 
System enables you to assign the Camber System to a different 
switch in each fl ight mode.