Cisco WAP2000 Access Point PoE WAP2000 Ficha De Dados
Códigos do produto
WAP2000
Data Sheet
© 2008 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Page 2 of 4
The Cisco WAP2000 can be powered from the included AC adapter or from a Power over Ethernet
(PoE) switch via Ethernet cabling, enabling it to be mounted in ceilings or high on walls where
power outlets may not be available.
Additional features like multiple basic service set identifiers (BSSIDs), wireless roaming, and auto-
channel selection give your business added flexibility to keep employees and guests connected.
The Cisco WAP2000 also features dual firmware images, so it remains functional if a firmware
upgrade process is disrupted.
Features
●
10BASE-T/100 BASE-TX Ethernet port, auto-sensing half/full duplex, and automatic
medium dependent interface (MDI) and MDI crossover (MDI-X) detection
●
Full backward compatibility with 802.11b
●
Easy installation and configuration via a web Interface
●
Dual images for resilient firmware upgrades
●
Supports Wired Equivalent Privacy (WEP), WPA Pre-Shared Key (WPA-PSK), WPA2-PSK,
WPA-ENT, and WPA2-ENT authentication (802.11i ready)
●
SMA detachable dipole antennae with 1x2 multiple-input, multiple-output (MIMO) to
increase coverage
●
Supports PoE or external DC power
●
Supports 4 BSSIDs and 802.1Q VLAN to service set identifier (SSID) mapping
●
Supports Simple Network Management Protocol (SNMP) and uses an intuitive web-based
interface
●
Wi-Fi Multimedia (WMM) wireless QoS support, upgradable to 802.11e
●
Supports wireless roaming based on 802.11F (Inter-Access Point Protocol [IAPP])
●
Supports access point mode, bridge mode, and repeater mode
●
Supports wireless client isolation
●
Metal casing
Specifications
Table 1 lists the specifications, package contents, and minimum requirements for the Cisco
WAP2000 Wireless-G Access Point.
Table 1.
Specifications for the Cisco WAP2000 Wireless-G Access Point: PoE
Specifications
Standards
IEEE 802.11g, IEEE 802.11b, IEEE 802.3, IEEE 802.3u, IEEE 802.3af (PoE), 802.1p (QoS
priority), 802.1Q (VLAN), 802.1X (security authentication), 802.11i ready (security WPA2),
802.11e ready (wireless QoS), 802.11F (wireless roaming)
priority), 802.1Q (VLAN), 802.1X (security authentication), 802.11i ready (security WPA2),
802.11e ready (wireless QoS), 802.11F (wireless roaming)
Ports
10BASE-T/100BASE-TX Ethernet, 12V DC power
Buttons
Reset
Cabling type
Unshielded twisted pair (UTP) Category 5
LEDs
Power, PoE, Wireless, Ethernet
Operating system
Linux
Setup/Configuration
Web user interface
Built-in web user interface for easy browser-based configuration (HTTP/HTTPS)