Zebra T40 Walkie Talkie P14MAA03A1BB Ficha De Dados

Códigos do produto
P14MAA03A1BB
Página de 16
TLKR T40 
Owner’s Manual
English
TLKR T40 Owner’s Manual 
  
Product Safety and RF Exposure for Portable 
Two-Way Radios
 
Attention!
Before using this product, read the RF energy awareness 
information and operating instructions in the Product Safety 
and RF Exposure booklet to ensure compliance with RF 
energy exposure limits.
Package Contents
TLKR T40 Radio* (2 units)
Belt Clip (2 units)
TLKR T40 Owner's Manual
EN
Before using this product, read the operating 
instructions for safe usage contained in the 
Product Safety and RF Exposure booklet 
enclosed with your radio.
Caution
Radio Controls
Antenna
Volume/
Channel 
Buttons
Call Button
Speaker
Microphone
Menu/Power 
button
PTT 
Button
Display
Preparing Your Radio
Installing the Battery
1. Make sure your radio is OFF.
2. To remove the battery compartment door, by pressing the 
tab at the bottom of the compartment door. Remove the 
door. Insert 3 AAA batteries into the battery compartment. 
3. Replace the battery compartment door.
Battery Level and Low Battery Alert 
1. Volume Level Indicator
2. Transmit/Receive 
Indicator
3. Keypad Lock Indicator
4. Scan Indicator
5. Battery Level Meter
6. Channel Indicator
Indicates that the battery is fully charged.
Blinks when battery is low; replace batteries 
immediately.
1
2
3
4
5
6
Basic Radio Operations
Read this reference guide completely before attempting to 
operate the unit.
Turning Your Radio On/Off
Press and hold the MENU/
 button to turn your radio ON/
OFF.
Adjusting the Volume
Adjust the volume by pressing the   and   buttons.
Adjusting the Sound (Key Beeps)
Your radio emits a beep each time one of the buttons is 
pressed (except the PTT button).
Press and hold the   button while turning the radio ON to 
switch the sound OFF. 
To turn this sound ON, turn the radio OFF and ON again 
without pressing the 
 
button.
Selecting a Channel
In order to speak to someone, both your radios must be set to 
the same channel.
To select a channel: 
1. MENU/
 button to enter Menu.
2.   or   to the required channel.
3. Press PTT button to confirm the selection. 
Talking on Your Radio
1.  Hold your radio 5–8 cm from your mouth. 
2. Press and hold the PTT button while speaking. The 
 
appears on the display.
3. Release the PTT button. You can now receive incoming 
calls. When you do, the   appears on the display. To 
respond, repeat procedure from step 1.
Note: When you continue to transmit for 60 seconds, the 
radio emits TX Time Out tone and the 
 icon 
flashes. The radio will stop transmitting.
Navigating through the Menu
1. To enter the Menu, press the MENU/
 button.
2. Additional presses of the MENU/
 buttonwill advance you 
through the Menu.
3. To exit the Menu function, do one of the following:
a. Press and hold the MENU/
 button.
b.Press the PTT button.
c.Wait 10 seconds until the unit automatically returns to 
“Normal” mode.
Features on Your Radio
Call Tone 
Your radio is equipped with a call tone.
To transmit a call tone, press the 
/
 button.
Channel Scan Mode
Enables your radio to scan for active channels. When activity 
is detected, your radio lands (stays) on that channel (for 2 
seconds). To transmit on that channel, press the PTT button. 
When activity on the landed channel ends, your radio 
continues scanning other channels.
To turn the channel scan ON:
1. MENU/
 to enter  Menu. Advance until 
 
blinks.
2. 
/
 to turn ON channel scan.
MENU/
 or PTT to turn OFF Scan mode.
Key Lock
Press and hold 
/  until   appears to lock the keypad.
Press and hold 
/  until   disappears to unlock the 
keypad.
Monitor Mode
Enables you to listen for weak signals on the current channel.
To turn the Monitor Mode ON:
1. MENU/
 button to enter menu.Advance through the menu 
until 
 icon blinks.
2. Press the 
/   button for continuous listening. The 
 
icon continues to blink.
To turn the Monitor Mode OFF:
Press the MENU/
 button to return to “Normal” mode. The 
 icon stops blinking.
Roger Beep
Sounds to indicate the end of a PTT transmission. It can be 
heard through the speaker when Key Beep is on. It cannot be 
heard through the speaker if Key Beep is turned off.
Press and hold the   button while turning the radio ON to 
turn the Roger Beep ON. Repeat the step to turn Roger Beep 
OFF.
Automatic Power Save
For better battery life, your radio is designed to switch to 
Power Save mode when there has been no transmissions 
after 3 seconds. The radio can receive transmissions in this 
mode.
Specifications
Channels
8 PMR
 Frequency
446.00625 - 446.09375 MHz
Power Source 3 AAA Alkaline Batteries 
Range
Up to 4 km*
Battery Life
16 Hours (under typical use conditions)
*Range may vary depending on environmental and/or topographical 
conditions.
Frequency Chart
Channel
Freq. (MHz)
Channel
Freq. (MHz)
1
446.00625
5
446.05625
2
446.01875
6
446.06875
3
446.03125
7
446.08125
4
446.04375
8
446.09375
Warranty Information
The authorized Motorola dealer or retailer where you 
purchased your Motorola two-way radio and/or original 
accessories will honour a warranty claim and/or provide 
warranty service.
Please return your radio to your dealer or retailer to claim 
your warranty service. Do not return your radio to Motorola.
In order to be eligible to receive warranty service, you must 
present your receipt of purchase or a comparable substitute 
proof of purchase bearing the date of purchase. The two-way 
radio should also clearly display the serial number. The 
warranty will not apply if the type or serial numbers on the 
product have been altered, deleted, removed, or made 
illegible.
What Is Not Covered By The Warranty
Defects or damage resulting from use of the Product in other 
than its normal and customary manner or by not following the 
instructions in this user manual.
Defects or damage from misuse, accident or neglect.
Defects of damage from improper testing, operation, 
maintenance, adjustment, or any alteration or modification of 
any kind.
Breakage or damage to aerials unless caused directly by 
defects in material or workmanship.
Products disassembled or repaired in such a manner as to 
adversely affect performance or prevent adequate inspection 
and testing to verify any warranty claim.
Defects or damage due to range.
Defects or damage due to moisture, liquid or spills.
All plastic surfaces and all other externally exposed parts that 
are scratched or damaged due to normal use.
Products rented on a temporary basis.
Periodic maintenance and repair or replacement of parts due 
to normal usage, wear and tear.
Copyright Information
The Motorola products described in this manual may include 
copyrighted Motorola computer programs stored in 
semiconductor memories or other media. Laws in the United 
States and other countries preserve for Motorola certain 
exclusive rights for copyrighted computer programs including, 
but not limited to, the exclusive right to copy or reproduce in 
any form the copyrighted computer program. Accordingly, 
any copyrighted Motorola computer programs contained in 
the Motorola products described in this manual may not be 
copied, reproduced, modified, reverse-engineered, or 
distributed in any manner without the express written 
permission of Motorola. Furthermore, the purchase of 
Motorola products shall not be deemed to grant either directly 
or by implication, estoppel, or otherwise, any license under 
the copyrights, patents or patent applications of Motorola, 
except for the normal non-exclusive license to use that arises 
by operation of law in the sale of a product.
Notes
Notes
*68015000921*
68015000921-A(EN)
U01UT070ZZA
Printed in China
MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the 
Stylized M logo are trademarks or registered trademarks of 
Motorola Trademark Holdings, LLC and are used under 
license. All other trademarks are the property of their 
respective owners.
© 2012 Motorola Solutions, Inc. All rights reserved.