ConiuGo 700100107 EasyGuard II 700100107 Manual Do Utilizador
Códigos do produto
700100107
16
Revision 9.0
GSM Alarm & Telemetry systems
#SIGNAL OK
Signal is higher then 8 and is good for the use of SMS services.
#SIGNAL ERROR
The checking of the send quality reports a failure; maybee a
hardware defect or defect antenna.
•
SIM-card-status
Here the status of the used SIM- card will be reported.
Possible answers:
#NO SIMCARD
No SIM card is in the unit.
#PIN READY
The PIN number which was entered is ok.
#SIM PUK
The SIM card needs a master PIN because the card is blocked
#SIM PIN
You have to enter the PIN number
#SIM ERROR
PIN number request sends an unknown error
•
Modemstatus
Shows the status of the internal GSM modem. Here will be shown possible
restarts of the module or a reset of the modem.
Possible answers:
#RESET!
The internal GSM modem will be resetted.
#NEUSTART
The modem will be switched on.
#UNBEKANNT
The internal modem is ready but is not tested right now.
#OK
The modem is ready.
•
ModemResetStatus
This value is a count-down for the communication between the
controller and the modem. The modem will be restarted at end of
this procedure. However, the modem even during this modem reset
registers incoming events and will reports them when the device is
booked into the GSM network.