Sanyo PLC-ET30L PLCET30L Manual Do Utilizador

   

– Projecting from the excessive slant angle to the screen may cause  

 

   

  keystone distortion and partial imperfect focus. See page 18.

– Check if "Contrast" or "Brightness" are adjusted properly See page 42. 

   

– Check if "Image level" is selected properly See page 41. 

   

– Check the LAMP REPLACE indicator. If it lights, the end of lamp life is 

   

  approaching. Replace the lamp with a new one promptly. See pages 

   

  59-60, 69. 

   

– Check the Lamp control function See page 49.

  The color is strange . 

– Check the Input signal, color system, video system, or computer  

 

   

  system mode. 

   

– Adjust the Image level properly. See page 41.

  Image is Left/Right reversed . 

– Check the Ceiling/Rear function. See page 45. 

  Image is Top/Bottom reversed . 

– Check the Ceiling function. See page 45.

  The image is distorted or runs off . 

– Check the "PC Adjustment" menu or "Screen" menu and adjust them.   

   

  See page 37-40, 45-47.

  The edge of image is distorted . 

– With maximum lens shift, image distortion may be observed.

  No sound 

– Check the audio cable connection from audio input source. 

   

– Adjust the audio source. 

   

– Press the Volume + button. See page 29. 

   

– Press the Mute button. See page 29. 

   

– When the AUDIO OUT is plugged in, the projector's built-in speaker is   

   

  not available. 

   

– Is the image projected? You will hear the sound only when the image is  

   

  projected.

  Auto PC adjustment function   

– Check the Input signal. Auto PC Adjustment function can not work.  

 

  does not work . 

  when 480p, 575p, 720p, 480i, 575i, 1035i, or 1080i is selected.  

   

  See page 38. 

   

– The Auto adj. icon turns gray and cannot be operated with the digital    

   

  signals. See page 38.

  Some displays are not seen  

– Check the Display function. See page 52. 

 

 

 

 

  during the operation .

  The setting does not remain after    – Make sure you selected "Store" after adjusting settings. Some settings  

  turning off power . 

  cannot be stored if not registered with "Store."

  Power management function does   – Power management function cannot work while "Freeze" or "No Show"  

  not work . 

  function is running.

– Check the power management function in the Setting. The power  

 

   

  management is set to “On” at the factory.