Texas Instruments 3.125 Gbps 2x2 LVDS Crosspoint Switch Evaluation Board DS25CP102EVK/NOPB DS25CP102EVK/NOPB Ficha De Dados
Códigos do produto
DS25CP102EVK/NOPB
DS25CP102EVK User Manual
Evaluation
This section provides recommended test setup procedure for the device evaluation. Figure 3
depicts a typical setup and instrumentation you may use for the device evaluation.
depicts a typical setup and instrumentation you may use for the device evaluation.
1. Configure the test setup as shown in Figure 3.
2. Set and enable the desired INn to OUTn drivers by selecting SEL0, SEL1, EN0 and EN1
according to Tables 1 – 2.
3. Apply + supply (3.3V typical) to the VDD and – supply (ground) to the VSS connectors.
4. Set desired pre-emphasis and/or equalization levels according to Tables 3 – 4.
5. Connect a signal source (signal generator, data source, or an LVDS driver) to the desired
INn inputs on the board and adjust the signal parameters (VOH, VOL, VCM) so that they
comply with the device input recommendations.
comply with the device input recommendations.
6. Connect an oscilloscope to the selected OUTn outputs and view the output signals with
an oscilloscope with the analog bandwidth of at least 5 GHz.
Figure 3. DS25CP102 Test Setup Example
Page 5 of 7