Texas Instruments Step Down Converter Bypass Mode Low Power Wireless Appl. Evaluation Module TPS62733EVM-726 TPS62733EVM-726 Ficha De Dados

Códigos do produto

TPS62733EVM-726

S001

Vout 2.1 V or 2.3 V

www.ti.com

Test Summary

4.1

Equipment

•

Adjustable dc power supply between 1.8 V and 4 V with adjustable current limit set to approximately
150 mA

•

Load: system load or resistive load

≥

•

Three Fluke 75 DMMs (equivalent or better)

•

Oscilloscope, model TDS222 (equivalent or better)

4.2

Equipment and EVM Setup

Table 1. Setup I/O Connections and Configuration for Evaluation of TPS62730, TPS62733 EVM

Jack and Component (Silk

Connect or Adjustment To:

Screen)

J1 (Vin)

Power supply positive lead, preset to 3.3 VDC, 150-mA current limit

J2-1 (+ SNS); input

Positive lead of DMM #1

J2-2 (- SNS); input

Negative lead of DMM #1

J3 (GND)

Power supply negative lead (3.3 VDC supply)

J4 (Vout)

Positive lead to system load or load resistance

J5-1 (+ SNS); output

Positive lead of DMM #2

J5-2 (- SNS); output

Negative lead of DMM #2

J6 (GND)

Negative lead to system load or load resistance

J7-1 (STAT)

Positive lead of DMM meter #3

J7-2 (GND)

Negative lead of DMM meter #3

JP1 (ON)

Apply shunt to ON (across pins 1 and 2) for converter operation

JP1 (Bypass)

Do not apply shunt to Bypass (across pins 2 and 3) until procedure calls for change.

Connect the meters, scope probes, output load, shunt, and input power supply as listed in

Table 1

and set

the oscilloscope to 200 ns/div, positive trigger, dc-coupled on CH1, ac-coupled and 10 mV/div on CH2.
Use additional channels or move probes as required view Vin, Vstat and Vbypass. Replace the resistive
load with a system load or decade load box if desired to vary the load between 1 k

and 21

Figure 1. EVM Schematic and Evaluation Setup

SLVU455A – April 2011 – Revised August 2012

TPS62730, TPS62733 Stepdown Converters With Bypass Mode for Ultralow-

Power Wireless Applications

Submit Documentation Feedback