Texas Instruments TPS43330EVM Evaluation Module TPS43330EVM TPS43330EVM Ficha De Dados
Códigos do produto
TPS43330EVM
D
IV
10V boost
11 V boost
G
N
D
V
R
E
G
D
IV
G
N
D
V
R
E
G
D
IV
7V boost
G
N
D
V
R
E
G
ENA
disabled
ENA
enabled
0
1
1
0
Introduction
www.ti.com
1
Introduction
The Texas Instruments TPS4333xEVM evaluation module (EVM) helps designers evaluate the operation
and performance of the TPS4333x family of Switch Mode Power Supplies – Multiple-output voltage
regulator.
and performance of the TPS4333x family of Switch Mode Power Supplies – Multiple-output voltage
regulator.
The EVM contains one DC / DC converter (see
).
Table 1. Device and Package Configurations
Converter
IC
Package
TPS43330QDAPQ1
TPS43332QDAPQ1
U1
DAP-38
TPS43335QDAPQ1
TPS43336QDAPQ1
2
Setup
This section describes the jumpers and connectors on the EVM as well and how to properly connect, set
up and use the TPS4333xEVM.
up and use the TPS4333xEVM.
2.1
Input/Output Connector Description
J1 – Input is the protected power input terminal for the converter with a voltage range from 2V-40V (Boost
enabled) or 4V-40V (Boost disabled). The terminal block provides a power (V
enabled) or 4V-40V (Boost disabled). The terminal block provides a power (V
bat
) and ground (GND)
connection to allow the user to attach the EVM to a cable. harness. The power path provides a series
Schottky diode for reverse battery protection.
Schottky diode for reverse battery protection.
J2 – VOUTA is the output terminal for the TPS4333x buck controller A. The terminal block provides a
power (VOUTA) and ground (GND) connection.
power (VOUTA) and ground (GND) connection.
J3 – VOUTB is the output terminal for the TPS4333x buck controller B. The terminal block provides a
power (VOUTB) and ground (GND) connection.
power (VOUTB) and ground (GND) connection.
JP1 – DIV is the jumper used to select the output voltage for the boost pre-regulator stage. The boost
output is 7V when DIV is low, 10V when DIV floating and 11V when DIV is pulled high.
output is 7V when DIV is low, 10V when DIV floating and 11V when DIV is pulled high.
Figure 1. DIV Jumper Settings
JP2 – ENA is the jumper used to enable buck controller A. The controller will be enabled when the ENA is
high and disabled when low.
high and disabled when low.
Figure 2. ENA Jumper Settings
2
TPS4333xEVM
SLVU457 – April 2011
© 2011, Texas Instruments Incorporated