Microchip Technology PICkit 3 Starter Kit DV164130 DV164130 Manual Do Utilizador
Códigos do produto
DV164130
PICkit™ 3 User’s Guide
DS51795A-page 56
© 2009 Microchip Technology Inc.
9.5
SETTINGS DIALOG
Select either Debugger>Settings or Programmer>Settings to open the Settings dialog
and set up the PICkit 3 programmer/debugger.
and set up the PICkit 3 programmer/debugger.
9.5.1
Settings Dialog, Program Memory Tab
This tab allows you to set up debug/programming options.
Note:
Tabs displayed will depend on the selected device.
TABLE 9-6:
PROGRAM MEMORY OPTIONS
Allow PICkit 3 to select
memories and ranges
memories and ranges
If selected, the PICkit™ 3 uses your selected device and
default settings to determine what to program.
default settings to determine what to program.
Manually select memories
and ranges
and ranges
If selected, you must determine the Memories, Program
Memory Range, and Program Options for the selected
device.
Memory Range, and Program Options for the selected
device.
Memories:
Program
Check to program Program Memory into target.
Configuration
Check to program Configuration bits into target.
Note: This memory is always programmed when
debugger selected as a debugger.
Note: This memory is always programmed when
debugger selected as a debugger.
EEPROM
Check to erase and then program EEPROM memory on
target, if available. Uncheck to erase EEPROM memory
on target.
target, if available. Uncheck to erase EEPROM memory
on target.
ID
Check to program ID Memory into target.
Boot Flash
If supported, check to program boot memory on target
Program Memory Range:
Start, End
The starting and ending hex address range in program
memory for programming, reading, or verification.
If you receive a programming error due to an incorrect
end address, you need to perform a reconnect, correct
the end address and program again.
Note: The address range does not apply to the Erase
function. The Erase function will erase all data on the
device.
memory for programming, reading, or verification.
If you receive a programming error due to an incorrect
end address, you need to perform a reconnect, correct
the end address and program again.
Note: The address range does not apply to the Erase
function. The Erase function will erase all data on the
device.
Program Options
:
Erase all before Program
Check to erase all memory before programming begins.
Unless programming new or already erased devices, it is
important to have this box checked. If not checked, the
device is not erased and program code will be merged
with the code already in the device.
Unless programming new or already erased devices, it is
important to have this box checked. If not checked, the
device is not erased and program code will be merged
with the code already in the device.
Preserve Program Memory
Range
Range
Check to preserve memory range.
Start, End – The starting and ending hex address range in
program memory for preservation.
Start, End – The starting and ending hex address range in
program memory for preservation.