Testo ComSoft 3 0554 0830 Ficha De Dados

5

4

Minimum system requirements
• PC with operating system

- Microsoft Windows 95 or better (if compatible)
- Microsoft Windows NT 4, Service pack 4, or better 
(if compatible).
- Windows 2000 or better (if compatible).

• CD-Rom drive
• Pentium 100 MHz
• 32 MB RAM
• 15 MB hard disk drive space free
• Free serial interface (COM) or corresponding adapter.

1. Place CD-ROM in drive

2. The installation menu will start up after a short time. If it

fails to start, click twice on “Setup.EXE” on the CD-ROM.

3. You are asked to enter the licence number (see sticker

on CD-ROM).
Restart may be necessary if it is the first installation.
Note: If the number input is not accepted it may be due
to the following:
- Is the shift button activated?
- Is “Num” in the separate digit pad activated?
- Was l entered instead of 1?
- Was o entered instead of 0?

4. Once confirmed, the installation continues and you are

asked to enter your name and company name.

5. The rest of the procedure is then menu-driven. Please

observe the notes and explanations beside the buttons.

Note: If “

protected” is activated, the “Range of

functions” register is not visible to the user and will not
be available later.

The Comsoft 3 software is used to save, read and analyse
separate measurement values and measurement series.
The main task of this program is the graphic display of
readings.
Readings are taken using Testo´s measuring instruments
and are transmitted via serial interface to your PC.
Data is read using Comsoft 3 software, which activates the
interfaces and makes all functions available.

There are suitable instrument drivers available for installing
each Testo instrument/system. They are especially adapted
to the range of instrument hardware and their operation.

Measured readings are logged with date and time. Values
are constantly updated during ONLINE measurements.