Extech Anemometer SDL350 Ficha De Dados
Códigos do produto
SDL350
2
SDL350-EU-EN-V1.2-11/11
1
2
3
4
5
Hot Wire
5
1
2
11
3
4
5
6
7
8
9
10
16
15
14
13
12
18
17
19
20
Introduction
Congratulations on your purchase of the Extech SDL350 Hot Wire Thermo-Anemometer
Datalogger. This meter displays and stores air velocity and temperature readings. Temperature
readings from the thermometer built into the probe or from an externally connected type K or J
thermocouple temperature probe can be displayed and recorded. Data is stored on an SD card for
transfer to a PC. This meter is shipped fully tested and calibrated and, with proper use, will provide
years of reliable service.
Datalogger. This meter displays and stores air velocity and temperature readings. Temperature
readings from the thermometer built into the probe or from an externally connected type K or J
thermocouple temperature probe can be displayed and recorded. Data is stored on an SD card for
transfer to a PC. This meter is shipped fully tested and calibrated and, with proper use, will provide
years of reliable service.
Safety
International Safety Symbols
This symbol, adjacent to another symbol or terminal, indicates the user must refer to the
manual for further information.
manual for further information.
Description
METER AND HOT WIRE PROBE
1.
Thermocouple input
2.
Hot Wire input plug
3.
Display for air velocity and air flow readings
4.
Units of measure
5.
HOLD / Backlight
key
6.
MAX-MIN key
7.
SET and Clock
key
8.
PC interface jack
9.
Reset key
10. Power Adaptor jack
11. SD card slot
12. ENTER and LOG key
13. Down
11. SD card slot
12. ENTER and LOG key
13. Down
▼
arrow and FUNCTION key
14. Up
▲
arrow and UNIT key
15. Power ON-OFF
key
16. Temperature reading with units of measure
17. Hot Wire probe cable
18. Telescoping probe handle
19. Protective cover (sensors underneath)
20. Colored dot must face air flow
17. Hot Wire probe cable
18. Telescoping probe handle
19. Protective cover (sensors underneath)
20. Colored dot must face air flow
HOT WIRE PROBE TOP (detail)
1.
Air stream must face into colored dot
2.
Air velocity sensor
3.
Sliding protective cover OPEN position
4.
Sliding protective cover CLOSED position
5.
Temperature sensor
NOTES:
Battery compartment, tilt stand, and tripod mount are located on the rear of the instrument.
Items 8, 9, and 10 are located behind the snap-off compartment cover on right side of meter.
Items 8, 9, and 10 are located behind the snap-off compartment cover on right side of meter.