Philips DIGITAL CAMERA DSC 2000K DSC2000K/00 Manual Do Utilizador
Códigos do produto
DSC2000K/00
7. Problem solving
If a fault occurs, first check the points listed below, refer to the Instructions for use again or
visit our website. If you are unable to remedy a problem by following these hints, consult your
dealer or contact the helpline (see ‘Helpline’). Never try to open the camera yourself as this
may result in injuries and will void the guarantee.
visit our website. If you are unable to remedy a problem by following these hints, consult your
dealer or contact the helpline (see ‘Helpline’). Never try to open the camera yourself as this
may result in injuries and will void the guarantee.
First, check all cables to ensure that they are connected correctly.
Problem
Possible cause / Solution
No photo is taken
Battery exhausted
while the Shutter
•
Recharge battery. See ‘(Re)charging the battery’.
button is pressed
Memory full
all the way down
•
Transfer photos to your PC or clear photos in order to create memory
space. See ‘Transferring/viewing photos’ and/or ‘Deleting photo’s’.
space. See ‘Transferring/viewing photos’ and/or ‘Deleting photo’s’.
Camera is still connected to the PC’s USB port
•
•
Disconnect the camera from the PC’s USB port or take the camera out
of its docking base.
of its docking base.
Poor light conditions
•
•
Try to improve the light conditions.
Camera turned off automatically
(no button pressed for one or two minutes)
•
(no button pressed for one or two minutes)
•
Turn the camera back on. See ‘Turning the camera on and off ’.
Camera not turned on
•
•
Turn on camera.
No memory space in internal memory or SD card
•
•
Delete unwanted photos (see ‘Deleting photos’) or insert new SD card
(see ‘Installing a Secure Digital (SD) memory card’).
(see ‘Installing a Secure Digital (SD) memory card’).
No reaction to
Battery exhausted
controls
•
Recharge battery. See ‘(Re)charging the battery’.
File transfer not
USB cable not properly connected
possible
•
Properly connect USB cable to both docking base and PC and be sure
the camera is placed on the docking base.
the camera is placed on the docking base.
USB driver not installed
•
•
Install USB driver and ‘Philips Photo Manager’ on your PC.
Not all images
The RAM memory installed in your PC may not have sufficient
can be transferred
storage space.
to the PC
•
Close all software programs and proceed to transfer your images. If the
problem persists, transfer images in batches and store each batch on
your hard drive before proceeding to the next batch. Make sure all the
images you want are stored before you clear the camera memory.
problem persists, transfer images in batches and store each batch on
your hard drive before proceeding to the next batch. Make sure all the
images you want are stored before you clear the camera memory.
ENGLISH
30