Kern SFE 30K10IPMParcel scales Weight range bis 30 kg SFE 30K10IPM Manual Do Utilizador

 

 

Annex page 7 of 12 

 

EC type-approval certificate no. DK 0199.312 

Seals shall bear the verification mark of a notified body or alternative mark of the manufacturer ac-
cording to ANNEX II, section 2.3 of the Directive 2009/23/EC. 

Access to the configuration and calibration facility requires that a calibration jumper is installed on the 
main board. 

Sealing of the cover of the enclosure - to prevent access to the calibration jumper and to secure the 
electronics against dismantling/adjustment - is accomplished with a brittle plastic sticker. The sticker 
is placed so access to one of the screws of the enclosure is prohibited (see figure 2, 4 and 6). 

Securing of the indicator, load receptor and load cell combined is done in one of the following ways: 

• 

Sealing of the load cell connector with the indicator by a lead wire seal. 

• 

Inserting the serial number of the load receptor as part of the principal inscriptions contained on the 
indicator identification label. 

• 

The load receptor bears the serial number of the indicator on its data plate. 

All peripheral interfaces are “protective”; they neither allow manipulation with weighing data or legal 
setup, nor change of the performance of the weighing instrument in any way that would alter the legal-
ity of the weighing. 

A green M-sticker shall be placed next to the CE mark on the inscription plate. 

The sticker with verification marks may be placed on or next to the inscription plate or on the front of 
the indicator. 

Printers covered by this type approval and other printers according to section 4.2, which have been 
subject to the conformity assessment procedure, shall not bear a separate green M-sticker in order to 
be used for legal transactions. 

A sticker with the CE mark of conformity and year of production is located on the identification plate 
which is located on the enclosure of the weight indicator. 

Issued by DELTA