Foxconn BLACKOPS Manual Do Utilizador
18
2
COM Connector : COM1
This motherboard supports one serial RS232 COM port for
legacy compatibility. User must purchase another RS232
cable with a 9-pin D-sub connector at one end to connect
with the external RS232 device and another end with 10-
pin female connector to connect with COM1 connector in
the motherboard.
legacy compatibility. User must purchase another RS232
cable with a 9-pin D-sub connector at one end to connect
with the external RS232 device and another end with 10-
pin female connector to connect with COM1 connector in
the motherboard.
Speaker Connector : SPeAKeR
The speaker connector is used to connect speaker of the
chassis.
chassis.
Serial ATA Connectors : SATA_1/2/3/4/5/6
The Serial ATA connector is used to connect with SATA
Hard Disk or CD devices which supporting this feature.
The current Serial ATA II interface allows up to 300MB/s
data transfer rate.
Hard Disk or CD devices which supporting this feature.
The current Serial ATA II interface allows up to 300MB/s
data transfer rate.
Fan Connectors : CPU_FAN, SYS_FAN, NB_FAN,
fAN1/2/3
fAN1/2/3
There are six fan headers on this motherboard. The fan
speed can be controlled and monitored in “PC Health
Status” section of the BIOS Setup. These fans can be
automatically turned off after the system enters S3, S4
and S5 sleeping states.
speed can be controlled and monitored in “PC Health
Status” section of the BIOS Setup. These fans can be
automatically turned off after the system enters S3, S4
and S5 sleeping states.
RLSD
SOUT
RI
GND
RTS
DSR
DTR
CTS
EMPTY
SIN
1 2
10
9
COM1
NC
SPKJ
EMPTY
SPEAKER
SPKJ
1
2
3
4
2
3
4
SYS_FAN
GND
+12V
SENSE
+12V
SENSE
FAN_1/2/3
_1/2/3
GND
+12V
SENSE
+12V
SENSE
NB_FAN
GND
+12V
SENSE
+12V
SENSE
CPU_FAN
GND
POWER
POWER
SENSE
CONTROL
1
1
1
1
SATA_1/2/3/4/5/6
GND
TX+
TX-
GND
GND
RX-
RX+
GND
1