AEG BMG 5612 520612 Manual Do Utilizador

16.  This blood pressure monitor is verified by auscultatory method. It is recommended 

that you check annex B of ANSI/AAMI SP-10:2002+A1:2003+A2:2006 for details of 
verification method if you need. 

a.  Open battery cover at the back of the monitor. 
b.  Load four batteries of the type “AA”. Please pay attention to  

polarity. 

c.  Close the battery cover. 
When the LCD shows the battery symbol  , replace all batteries  
with new ones. 
Rechargeable batteries are not suitable for this monitor.
Remove the batteries if the monitor will not be used for a month or more to avoid 
relevant damage of battery leakage.

 Do not let battery fluid get into your eyes. If it should get in your eyes, immediately 

rinse with plenty of clean water and contact a physician. 

Power supply operation
You can operate the device also with a power supply unit (power supply unit not 
included in the scope of delivery).

 When using a power supply unit, take care that the listed voltage matches the 

voltage of the outlet. Also check that the output current and the polarity of the power 
supply unit match the data on the sphygmomanometer. (Power supply unit output:  
DC 6 V, 600 mA, 

)

 Before operating the device with a power supply unit, make sure that the device is 

switched off and that no batteries have been inserted. Do not disconnect the power 
supply unit while operating the device.

a.  Plug the power supply unit into a correctly installed safety socket.
b.  Connect the device to the power supply unit by inserting the plug of the power 

supply unit into the DC 6 V socket (right side of the device).

If the device is not to be used for some time, disconnect the power supply unit from 
the outlet. Also pull the plug of the power supply unit from the DC 6 V socket of the 
device.