Atmel Evaluation Kit for ATxmega32E5, 8/16-bit AVR XMEGA Microcontroller Atmel ATXMEGAE5-XPLD ATXMEGAE5-XPLD Ficha De Dados
Códigos do produto
ATXMEGAE5-XPLD
Atmel 8153H–AVR-ATxmega8E5-ATxmega16E5-ATxmega32E5_Datasheet–07/2014
Features
z
High-performance, low-power Atmel® AVR® XMEGA® 8/16-bit Microcontroller
z
Nonvolatile program and data memories
z
8K –32KBytes of in-system self-programmable flash
z
2K – 4KBytes boot section
z
512Bytes – 1KBytes EEPROM
z
1K – 4KBytes internal SRAM
z
Peripheral features
z
Four-channel enhanced DMA controller with 8/16-bit address match
z
Eight-channel event system
z
Asynchronous and synchronous signal routing
z
Quadrature encoder with rotary filter
z
Three 16-bit timer/counters
z
One timer/counter with 4 output compare or input capture channels
z
Two timer/counter with 2 output compare or input capture channels
z
High resolution extension enabling down to 4ns PWM resolution
z
Waveform extension for control of motor, LED, lighting, H-bridge, high drives and more
z
Fault extension for safe and deterministic handling and/or shut-down of external driver
z
CRC-16 (CRC-CCITT) and CRC-32 (IEEE 802.3) generator
z
XMEGA Custom Logic (XCL) module with timer, counter and logic functions
z
Two 8-bit timer/counters with capture/compare and 16-bit cascade mode
z
Connected to one USART to support custom data frame length
z
Connected to I/O pins and event system to do programmable logic functions
z
MUX, AND, NAND, OR, NOR, XOR, XNOR, NOT, D-Flip-Flop, D Latch, RS Latch
z
Two USARTs with full-duplex and single wire half-duplex configuration
z
Master SPI mode
z
Support custom protocols with configurable data frame length up to 256-bit
z
System wake-up from deep sleep modes when used with internal 8MHz oscillator
z
One two-wire interface with dual address match (I
2
C and SMBus compatible)
z
Bridge configuration for simultaneous master and slave operation
z
Up to 1MHz bus speed support
z
One serial peripheral interface (SPI)
z
16-bit real time counter with separate oscillator and digital correction
z
One sixteen-channel, 12-bit, 300ksps Analog to Digital Converter with:
z
Offset and gain correction
z
Averaging
z
Over-sampling and decimation
z
One two-channel, 12-bit, 1Msps Digital to Analog Converter
z
Two Analog Comparators with window compare function and current sources
z
External interrupts on all general purpose I/O pins
z
Programmable watchdog timer with separate on-chip ultra low power oscillator
z
QTouch® library support
z
Capacitive touch buttons, sliders and wheels
z
Special microcontroller features
z
Power-on reset and programmable brown-out detection
z
Internal and external clock options with PLL
z
Programmable multilevel interrupt controller
z
Five sleep modes
z
Programming and debug interface
z
PDI (Program and Debug Interface)
z
I/O and Packages
z
26 programmable I/O pins
z
7x7mm 32-lead TQFP
z
5x5mm 32-lead VQFN
z
4x4mm 32-lead UQFN
z
Operating Voltage
z
1.6 – 3.6V
z
Operating frequency
z
0 – 12MHz from 1.6V
z
0 – 32MHz from 2.7V
8/16-bit Atmel AVR XMEGA Microcontrollers
ATxmega32E5 / ATxmega16E5 / ATxmega8E5
Preliminary