Atmel ARM-Based Evaluation Kit for SAM4S16C, 32-Bit ARM® Cortex® Microcontroller ATSAM4S-WPIR-RD ATSAM4S-WPIR-RD Ficha De Dados
Códigos do produto
ATSAM4S-WPIR-RD
917
SAM4S Series [DATASHEET]
Atmel-11100G-ATARM-SAM4S-Datasheet_27-May-14
• RINDE: Response Index Error
0: No error.
1: A mismatch is detected between the command index sent and the response index received. Cleared when writing in the
1: A mismatch is detected between the command index sent and the response index received. Cleared when writing in the
HSMCI_CMDR.
• RDIRE: Response Direction Error
0: No error.
1: The direction bit from card to host in the response has not been detected.
1: The direction bit from card to host in the response has not been detected.
• RCRCE: Response CRC Error
0: No error.
1: A CRC7 error has been detected in the response. Cleared when writing in the HSMCI_CMDR.
1: A CRC7 error has been detected in the response. Cleared when writing in the HSMCI_CMDR.
• RENDE: Response End Bit Error
0: No error.
1: The end bit of the response has not been detected. Cleared when writing in the HSMCI_CMDR.
1: The end bit of the response has not been detected. Cleared when writing in the HSMCI_CMDR.
• RTOE: Response Time-out Error
0: No error.
1: The response time-out set by MAXLAT in the HSMCI_CMDR has been exceeded. Cleared when writing in the
1: The response time-out set by MAXLAT in the HSMCI_CMDR has been exceeded. Cleared when writing in the
HSMCI_CMDR.
• DCRCE: Data CRC Error
0: No error.
1: A CRC16 error has been detected in the last data block. Cleared by reading in the HSMCI_SR.
1: A CRC16 error has been detected in the last data block. Cleared by reading in the HSMCI_SR.
• DTOE: Data Time-out Error
0: No error.
1: The data time-out set by DTOCYC and DTOMUL in HSMCI_DTOR has been exceeded. Cleared by reading in the
1: The data time-out set by DTOCYC and DTOMUL in HSMCI_DTOR has been exceeded. Cleared by reading in the
HSMCI_SR.
• CSTOE: Completion Signal Time-out Error
0: No error.
1: The completion signal time-out set by CSTOCYC and CSTOMUL in HSMCI_CSTOR has been exceeded. Cleared by
1: The completion signal time-out set by CSTOCYC and CSTOMUL in HSMCI_CSTOR has been exceeded. Cleared by
reading in the HSMCI_SR. Cleared by reading in the HSMCI_SR.
• FIFOEMPTY: FIFO empty flag
0: FIFO contains at least one byte.
1: FIFO is empty.
1: FIFO is empty.
• XFRDONE: Transfer Done flag
0: A transfer is in progress.
1: Command Register is ready to operate and the data bus is in the idle state.
1: Command Register is ready to operate and the data bus is in the idle state.