Mikroelektronika MikroE Development Kits MIKROE-1432 Ficha De Dados

1. Introduction

Once you have soldered the headers your 
board is ready to be placed into desired 
mikroBUS™ socket. Make sure to align the 
cut in the lower-right part of the board 
with the markings on the silkscreen at the 
mikroBUS™ socket. If all of the pins are 

aligned correctly, push the board all 

the way into the socket.

3. Plugging the board in

2

3

2. Soldering the headers

1

4. Essential features

Turn the board upward again. Make sure 
to align the headers so that they are 
perpendicular to the board, then solder the 
pins carefully.

Turn the board upside down so that 
bottom side is facing you upwards. Place 
shorter parts of the header pins in both 
soldering pad locations.

Before using your click board™, make sure 
to solder 1x8 male headers to both left 
and right side of the board. Two 1x8 male 
headers are included with the board in 
the package.

click

BOARD

www.mikroe.com

Adapter click Manual

0 100000 023860

Adapter Click

™

 is an accessory board in 

™

 form factor. It’s a compact 

and easy solution for adding mikroBUS™ 
to IDC10 adapter to your design. It 
features 2x5 connection pads and two 
jumpers for SPI/I

2

C selection. Adapter 

Click

™

 communicates with the target board 

microcontroller via 

™ 

I

2

C (SDA, 

SCL), SPI (MISO, MOSI, SCK, CS), UART 
(RX, TX), INT and PWM lines. The board is 
designed to use 3.3V and 5V power supply.

Adapter 

click

There are two ways of establishing such 
connection: using male or female IDC10 
connectors. Both are provided with the 
package. You may solder male IDC10 header 
on the top side of Adapter Click™ and connect 
the  add-on  board  directly  or  via  IDC10  fl at 
cable. In some cases, female header socket is 
a better choice. Solder it either on the top, or 
the bottom side, depending on which one is 
more convenient in given circumstances.