Mikroelektronika MikroE Development Kits MIKROE-1423 Ficha De Dados

1. Introduction

Once you have soldered the headers your 
board is ready to be placed into desired 
mikroBUS™ socket. Make sure to align the 
cut in the lower-right part of the board 
with the markings on the silkscreen at the 
mikroBUS™ socket. If all of the pins are 

aligned correctly, push the board all 

the way into the socket.

3. Plugging the board in

2

3

2. Soldering the headers

1

4. Essential features

Turn the board upward again. Make sure 
to align the headers so that they are 
perpendicular to the board, then solder the 
pins carefully.

Turn the board upside down so that 
bottom side is facing you upwards. Place 
shorter parts of the header pins in both 
soldering pad locations.

Before using your click board™, make sure 
to solder 1x8 male headers to both left 
and right side of the board. Two 1x8 male 
headers are included with the board in 
the package.

click

BOARD

www.mikroe.com

BarGraph click Manual

0 100000 023754

BarGraph Click

™

 is an accessory board in 

™

 form factor. It’s a compact 

and easy solution for adding ten-segment 
light bar display to your design. It features 

 light bar display as well 

as two 

 shift registers. BarGraph 

Click

™

 communicates with the target board 

microcontroller via 

™ 

SPI (MOSI, 

MISO, SCK, CS),  RST and PWM lines. The 
board is designed to use 3.3V and 5V 
power supply. LED diode (GREEN) indicates 
the presence of power supply.

BarGraph 

click

BarGraph Click™ with it’s 

and 

  ICs gives additional 10 

segment light bar display to your design.

 

The 

IC contains an 8-bit serial-

in, parallel/serial-out shift register as well 
as 8-bit storage register. The storage 
registers has parallel 3-state outputs. 
Separate clocks are provided for both the 
shift and storage register. Shift register 
has a direct overriding clear input.