Mikroelektronika MikroE Development Kits MIKROE-1430 Ficha De Dados

1. Introduction

Once you have soldered the headers your 
board is ready to be placed into desired 
mikroBUS™ socket. Make sure to align the 
cut in the lower-right part of the board 
with the markings on the silkscreen at the 
mikroBUS™ socket. If all of the pins are 

aligned correctly, push the board all 

the way into the socket.

3. Plugging the board in

2

3

2. Soldering the headers

1

4. Essential features

Turn the board upward again. Make sure 
to align the headers so that they are 
perpendicular to the board, then solder the 
pins carefully.

Turn the board upside down so that 
bottom side is facing you upwards. Place 
shorter parts of the header pins in both 
soldering pad locations.

Before using your click board™, make sure 
to solder 1x8 male headers to both left 
and right side of the board. Two 1x8 male 
headers are included with the board in 
the package.

click

BOARD

www.mikroe.com

EVE click Manual

0 100000 023846

EVE Click

™

 is an accessory board in 

™

 form factor. It’s a compact and 

easy solution for adding graphics controller 
to your design. It features 

 graphics 

controller,  flat  cable  connector, 

audio amplifier, LED diode as well as screw 
terminals. EVE Click

™

 communicates with the 

target board microcontroller via 

™ 

SPI (MISO, MOSI, SCK, CS), INT, RST and AN 
lines. The board is designed to use 3.3V 
power  supply  only.  LED  diode  (GREEN) 
indicates the presence of power supply.

EVE 

click

EVE Click™ with it’s 

IC is embedded 

video engine controller that combines display, 
audio and touch-screen features. It has SPI 
interface to main board microcontroller (up to 
30 MHz), video RGB parallel output interface, 
mono audio channel output with PWM (via 
screw terminals), sound synthesizer, PWM 
backlight dimming control, 4-wires touch-
screen with touch force sensing, several 
power modes and many more.