Olimex Development board for STM32F407ZGT6 CORTEX-M4 microcontroller with Ethernet, USB host, USB-OTG STM32-E407 STM32-E407 Manual Do Utilizador
Códigos do produto
STM32-E407
OLIMEX© 2013
STM32-E407 user's manual
CHAPTER 5 CONTROL CIRCUITY AND HARDWARE MODULES
5. Introduction to the chapter
Here you can find information about reset circuit and quartz crystals locations, the power supply
circuit is discussed.
circuit is discussed.
5.1 Reset
STM32-E407's reset circuit includes R5 (10KΩ), R6 (1 KΩ), C19 (100nF) and a RESET button.
5.2 Clocks
There are two quartz crystals available on the board:
12 MHz quartz crystal Q1 is connected to pins 23 and 24 of the CORTEX-M4F processor.
Quartz crystal Q2 is a 32 768Hz RTC (real-time clock) and is connected to pins 8 and 9.
5.3 Power supply circuit
The power supply circuit of STM32-E407 allows flexible input supply from 6V to 16V direct
current. This means a wide range of power supplies, adapters, converters are applicable. The
maximum amperage the board can draw is 1A.
current. This means a wide range of power supplies, adapters, converters are applicable. The
maximum amperage the board can draw is 1A.
Note that the Li-Po battery connector cannot be used to fully power the board. It's function is to
give an option to save internal data if the board needs to be relocated. It will keep the RTC alive, for
instance.
give an option to save internal data if the board needs to be relocated. It will keep the RTC alive, for
instance.
If you have successfully powered the board the red PWR LED will turn on. Note that it is possible
to have the PWR LED on even if there isn't enough power for proper operation of the board and all
the peripherals currently connected.
to have the PWR LED on even if there isn't enough power for proper operation of the board and all
the peripherals currently connected.
Page 13 of 30