STMicroelectronics 19V - 90W Adapter with PFC for Laptop computers using the L6563H and L6699 EVL6699-90WADP EVL6699-90WADP Ficha De Dados

Códigos do produto
EVL6699-90WADP
Página de 38
Current sensing, OCP and OLP
L6699
24/38
Doc ID 022835 Rev 2
Current sensing, OCP and OLP
In the L6699 the current sense input ISEN (pin 6) senses the current flowing in the resonant 
tank to perform multiple tasks:
1.
Primary overcurrent protection (OCP function).
2. 
Hard-switching cycles prevention at startup (see 
).
3. 
Capacitive-mode detection during operation (see 
). 
In this section the discussion is concentrated on the OCP function.
Unlike PWM-controlled converters, where energy flow is controlled by the duty cycle of the 
primary switch (or switches), in a resonant half bridge the duty cycle is fixed and energy flow 
is controlled by its switching frequency. This has an impact on the way current limitation can 
be realized. While in PWM-controlled converters energy flow can be limited simply by 
terminating switch conduction in advance when the sensed current exceeds a preset 
threshold (cycle-by-cycle limitation), in a resonant half bridge the most efficient way to 
reduce an excessive current level is to increase the switching frequency, i.e. the oscillator 
frequency. 
In 
 and 
 a couple of current sensing methods are illustrated.
Note:
The L6699 must sense the instantaneous tank current for proper operation of the smooth 
startup function and the capacitive-mode detection circuit. Therefore, if a smoothing RC 
circuit (the one shown in the dashed box) is used to reduce the noise level on the ISEN pin, 
its time constant RF CF should be in the range of 100 - 200 ns. With slightly longer time 
constants it is recommended that converter operation close to the capacitive-mode 
boundary and during short-circuit, as well as at the end of the smooth-start phase, be 
checked for possible hard-switching cycles. With considerably longer time constants (> 200 
ns) hard-switching under the above mentioned conditions becomes very likely. 
Figure 18.
Current sensing techniques 
with sense resistor
Figure 19.
Current sensing techniques 
“lossless”, with capacitive 
shunt
         
         
!-V
, 

#R
2S
)
#R
/PTIONAL
2
&
#
&
!-V
, 

#R
#S
)
#R
2S
/PTIONAL
2
&
#
&