Reely 1:10 Deathwatcher 4WD TC-04 RtR 2.4 GHz FS53101 M Ficha De Dados
Códigos do produto
FS53101 M
37
1. Release throttle/braking lever, vehicle rolls to a halt (or does not move, if required, correct trimming), lever is in
neutral position
2. Drive forwards, slowly pull the throttle/brake lever towards the handle
3. Drive forwards and then brake (vehicle slows down; does not roll to a halt slowly); push throttle/brake lever away
from the handle without stopping.
4. Drive forwards and then backwards (wait briefly between changes and leave the lever in its neutral position!).
Wait briefly
If the neutral position is not correct (e.g. trimming control slightly off), you cannot switch between forward
and reverse driving. If you have this problem, correct the trimming for the driving function at the transmitter
or perform speed controller programming (see chapter 10).
and reverse driving. If you have this problem, correct the trimming for the driving function at the transmitter
or perform speed controller programming (see chapter 10).
Stop driving immediately if the vehicle shows unusual responses to the remote commands or if the vehicle
does not respond at all.
does not respond at all.
This behaviour could be caused by low driving batteries, low batteries/rechargeable batteries in the re-
mote control or by too great a distance between vehicle and remote control.
mote control or by too great a distance between vehicle and remote control.
A coiled telescopic aerial, disturbances on the radio channel used (e.g. other models, radio transmissions
from other devices) or adverse transmission/reception conditions could also be a cause for unusual re-
sponses of the vehicle.
from other devices) or adverse transmission/reception conditions could also be a cause for unusual re-
sponses of the vehicle.
Since the receiver is supplied with power through the speed controller BEC and thus through the driving
battery, low or empty driving batteries will cause unintentional movement of the vehicle (e.g. twitching of
the steering servo, etc.). For example, the voltage of the driving battery decreases for a short time under
full throttle, so that the receiver will no longer receive the required operating voltage. The vehicle will speed
up, but the steering servo does not react properly. Stop operating the vehicle at once and use a new, fully
charged driving battery.
battery, low or empty driving batteries will cause unintentional movement of the vehicle (e.g. twitching of
the steering servo, etc.). For example, the voltage of the driving battery decreases for a short time under
full throttle, so that the receiver will no longer receive the required operating voltage. The vehicle will speed
up, but the steering servo does not react properly. Stop operating the vehicle at once and use a new, fully
charged driving battery.
Before the next drive, wait for at least 5 – 10 minutes until motor and speed controller have cooled down
sufficiently.
sufficiently.
¨
¨
¨
¨
¨