HK Audio SOUNDHOUSE ONE AKTIV PA-SET 1990009 Ficha De Dados

Códigos do produto

1990009

RS 15 Sub A Manual 1.1

ENGLISH

Welcome to the
PowerWorks

family!

The RS 15 A SUB is an active subwoofer featuring an additional stereo

power amp for driving PowerWorks

RS 82 or RS 122 satellite speakers.

All electronic circuits required to operate the system are housed in the

subwoofer enclosure. This includes crossovers, frequency response com-

pensation circuitry, and separate limiters for the satellites and subwoofer,

as well as power amps and protective circuits.

You no longer have to worry about tweaking frequencies and levels.

It’s plug & play all the wayæsimply set up the system components,

connect five cords, and you're ready to roll.

Here’s hoping you enjoy using your rig as much as we enjoyed

designing it!

Your PowerWorks

team

Control Features and Connectors

1. Inputs

The two electronically balanced XLR ports serve as audio signal inputs.

You also have two parallel outputs (Through) available for connecting

additional power amps. The RS 15 Sub A can handle a stereo or mono

signal, so you can combine two systems and operate each in mono mode

to provide sound reinforcement for larger venues. Each input is equipped

with a dedicated Gain knob that controls its sensitivity, enabling you to

adjust the RS 15 Sub A’s power amps to match the given input signal

level.

Note:

If you want to operate the RS 15 Sub A in mono mode, you must patch

the mono input signal through to the second input of the RS 15 Sub A

using a microphone cord. In other words, connect the cord from the

Through port of the input that you're using to the second input.

This is the only way the mono signal will be sent to both satellites.

2. Speaker Outputs

Satellites (RS 82 or RS 122) connect to these two Speakon sockets. The

satellite power amps’ impedance is four ohms; never connect speakers

rated lower than four ohms.

3. Mains

Use this socket to connect RS 15 SUB A to a mains power supply. Before

you plug the system into a wall outlet, ensure your local mains voltage

matches the specification indicated on the device. If you attempt to run

RS 15 SUB A on the wrong mains voltage, you can seriously damage the

power amps.

4. Power On

Once you have connected all the required cords, you can switch the

system on.

5. Ground Lift

This switch separates the signal ground from the chassis ground,

enabling you to eliminate potential ground loops.

CAUTION: Never tape over the plug’s ground terminal - this

endangers lives!

INPUT

THROUGH

GAIN

LEFT

TO SATELLITE LEFT

INPUT

THROUGH

GAIN

RIGHT

150 WATTS @ 4 OHMS

TO SATELLITE RIGHT

150 WATTS @ 4 OHMS

GROUND

ON OFF

RS 15 Sub A BDA 1.1 30.08.2004 13:30 Uhr Seite 5 (Schwarz Bogen)