Siemens SPS starter kit 6ED1057-3BA00-0AA8 12 Vdc, 24 Vdc 6ED1057-3BA00-0AA8 Ficha De Dados
Códigos do produto
6ED1057-3BA00-0AA8
LOGO! installation and wiring
2.2 Installing/removing LOGO!
LOGO!
34
Manual, 06/2014, A5E33039675
Removal
To remove LOGO! if you have installed only one LOGO! Base Module, follow these steps:
1. Insert a screwdriver into the eyelet at the bottom of the slide interlock and move the latch
1. Insert a screwdriver into the eyelet at the bottom of the slide interlock and move the latch
downward.
2. Swing the LOGO! Base Module off the DIN rail.
To remove LOGO! if you have connected at least one expansion module to the LOGO! Base
Module, follow these steps:
1. Using a screwdriver, push the integrated slide interlock to the right.
2. Slide the expansion module off towards the right.
3. Insert a screwdriver into the eyelet at the bottom of the slide interlock and lever it
1. Using a screwdriver, push the integrated slide interlock to the right.
2. Slide the expansion module off towards the right.
3. Insert a screwdriver into the eyelet at the bottom of the slide interlock and lever it
downward.
4. Swing the expansion module off the profile rail.
Repeat steps 1 to 4 for all other expansion modules.
Repeat steps 1 to 4 for all other expansion modules.
Note
When removing modules, be sure to disengage the slide interlock of the module that
When removing modules, be sure to disengage the slide interlock of the module that
connects it to the next module. When removing multiple modules, it is easier to start with the
last module on the right side.