Siemens SPS starter kit 6ED1057-3BA00-0AA8 12 Vdc, 24 Vdc 6ED1057-3BA00-0AA8 Ficha De Dados
Códigos do produto
6ED1057-3BA00-0AA8
Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
86
Manual, 06/2014, A5E33039675
4. Select the retentivity setting: Press or
The display now shows:
5. Confirm your entries with OK.
Note
For further information on the protection mode, refer to the topic "Parameter protection
For further information on the protection mode, refer to the topic "Parameter protection
(Page 129)".
For further information on retentivity, refer to the topic "Retentivity (Page 129)".
You can modify the protection mode and retentivity setting only in programming mode. This
For further information on retentivity, refer to the topic "Retentivity (Page 129)".
You can modify the protection mode and retentivity setting only in programming mode. This
is not possible in parameter assignment mode.
LOGO! displays protection mode ("+" or "-") and retentivity ("R" or "/") settings only where
LOGO! displays protection mode ("+" or "-") and retentivity ("R" or "/") settings only where
you can actually change these settings.
Verification of the circuit program
You have now completed the program branch for Q1 and LOGO! shows you the output Q1.
You can once again view the circuit program on the display. Use the keys to browse the
circuit program; that is, press or to move from block to block, and to move between
the inputs at a block.
Closing the programming mode
When you finish programming, you can exit the programming mode by following these steps:
1. Return to the programming menu: Press ESC
2. Return to the main menu: Press ESC
3. Move the cursor to "
1. Return to the programming menu: Press ESC
2. Return to the main menu: Press ESC
3. Move the cursor to "
①
": Press or
4. Confirm "
①
": Press OK
LOGO! is back in RUN mode: