Siemens SPS starter kit 6ED1057-3BA10-0AA8 6ED1057-3BA10-0AA8 Ficha De Dados
Códigos do produto
6ED1057-3BA10-0AA8
Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
74
Manual, 06/2014, A5E33039675
To change the name of your circuit program, proceed in the same way.
Note
You can change the name of the circuit program in programming mode only. If you have
You can change the name of the circuit program in programming mode only. If you have
saved a password-protected circuit program, you can change the name of the circuit
program only after you have entered the correct password (refer to Section "Password for
circuit program protection (Page 74)"). You can read the name in both programming mode
and parameter assignment mode.
3.7.5
Password for circuit program protection
You can protect a circuit program from unauthorized access by assigning it a password.
You can assign, change, or deactivate a program password from a LOGO! Basic,
You can assign, change, or deactivate a program password from a LOGO! Basic,
LOGO!Soft Comfort or a LOGO! TDE.
Note
There is only one circuit program protection password that you can assign for LOGO!.
There is only one circuit program protection password that you can assign for LOGO!.
Assigning a program password from LOGO! Basic
A password can have a maximum length of 10 characters, and consists only of uppercase
letters. On LOGO! Basic, you can assign, edit or deactivate the password only in the
programming mode.
To enter a password, follow these steps in the programming menu:
1. Move the cursor to "
To enter a password, follow these steps in the programming menu:
1. Move the cursor to "
①
": Press or
2. Confirm "
①
": Press OK
3. Move the cursor to "
②
": Press or
4. Confirm "
②
": Press OK