Phoenix Contact 2701399 NLC-START-01 NANOLINE STARTER KIT NPN-TRANSISTOR 2701399 Ficha De Dados

Códigos do produto

2701399

Getting Started and Tutorial

2373_en_B

PHOENIX CONTACT

2-5

2.3

Starting nanoNavigator

This section describes starting nanoNavigator and getting ready to create a project. Follow

these steps:

From the Windows “Start” menu, select

“Programs... Phoenix Contact... nanoNavigator... nanoNavigator” to start the program.

Each time nanoNavigator starts, it displays a startup dialog box (see Figure 2-2).

Figure 2-2

nanoNavigator startup dialog box

The next step depends on whether or not there is a physical connection between the

nanoLC and PC. Do one of the following:

–

If nanoLC is connected to the PC, select the “Run Connection Wizard” button. This

displays the “nanoLC Connection Wizard” (see Figure 2-3). If there is a project

loaded on the nanoLC, nanoNavigator displays a message indicating that a project

exists and the “Upload” button is available. If there is no project on the nanoLC,

nanoNavigator displays a message to that effect and the “Upload” button is grayed

out. In either case, click the “New” button. nanoNavigator automatically detects the

nanoLC configuration and displays the initial flow chart workspace.

If you need to update the firmware in the nanoLC, select the “Run Connection Wizard”