ZyXEL VMG1312-B10A VMG1312-B10A-EU01V1F Ficha De Dados
Códigos do produto
VMG1312-B10A-EU01V1F
Chapter 7 Wireless
VMG1312-B10A User’s Guide
125
7.8 The Others Screen
Use this screen to configure advanced wireless settings. Click Network Setting > Wireless >
Others. The screen appears as shown.
Others. The screen appears as shown.
See
for detailed definitions of the terms listed in this screen.
Figure 40
Network Setting > Wireless > Others
The following table describes the labels in this screen.
Table 27
Network Setting > Wireless > Others
LABEL
DESCRIPTION
RTS/CTS
Threshold
Threshold
Data with its frame size larger than this value will perform the RTS (Request To Send)/CTS
(Clear To Send) handshake.
(Clear To Send) handshake.
Enter a value between 0 and 2347.
Fragmentation
Threshold
Threshold
This is the maximum data fragment size that can be sent. Enter a value between 256 and
2346.
2346.
Auto Channel
Timer
Timer
If you set the channel to Auto in the Network Setting > Wireless > General screen,
specify the interval in minutes for how often the Device scans for the best channel. Enter 0
to disable the periodical scan.
specify the interval in minutes for how often the Device scans for the best channel. Enter 0
to disable the periodical scan.
Output Power
Set the output power of the Device. If there is a high density of APs in an area, decrease
the output power to reduce interference with other APs. Select one of the following: 20%,
40%, 60%, 80% or 100%.
the output power to reduce interference with other APs. Select one of the following: 20%,
40%, 60%, 80% or 100%.
Beacon Interval
When a wirelessly networked device sends a beacon, it includes with it a beacon interval.
This specifies the time period before the device sends the beacon again.
This specifies the time period before the device sends the beacon again.
The interval tells receiving devices on the network how long they can wait in low power
mode before waking up to handle the beacon. This value can be set from20ms to 1000ms.
A high value helps save current consumption of the access point.
mode before waking up to handle the beacon. This value can be set from20ms to 1000ms.
A high value helps save current consumption of the access point.
DTIM Interval
Delivery Traffic Indication Message (DTIM) is the time period after which broadcast and
multicast packets are transmitted to mobile clients in the Power Saving mode. A high DTIM
value can cause clients to lose connectivity with the network. This value can be set from 1
to 100.
multicast packets are transmitted to mobile clients in the Power Saving mode. A high DTIM
value can cause clients to lose connectivity with the network. This value can be set from 1
to 100.