Buffalo TeraStation 1200 TS1200D0202-EU Ficha De Dados

37

If a drive fails, NAS Navigator2 and Settings will show an error message.

Notes: 
•  Do not unplug a running drive. Dismount it first or shut down the TeraStation before swapping a working 

drive. If you remove the drive without properly dismounting it, data may be lost or the TeraStation may 
malfunction.

•  Use a Buffalo OP-HDBST series drive of the same size or larger (the same size if using RMM) as the 

replacement drive. If a larger drive is used, the extra space will not be usable in a RAID array.

•  To avoid damaging the TeraStation with static electricity, ground yourself by touching something made of 

metal before handling any sensitive electronic parts.

•  After a drive is replaced, it will take about 30 minutes before normal file reading and writing are restored. 

Settings may not be accessible during this period.

•  Do not change the order of the hard drives in the TeraStation. For example, pulling out drive 1 and replacing 

it with drive 2 may cause data to be corrupted or lost.

•  If a new drive is not recognized after installing it, click Rediscover Disk in Settings.
•  For TS1400D models, do not replace 2 or more drives at the same time with new drives while the TeraStation 

is on. If you do, it may cause unexpected behavior.

This section describes replacing a drive with 

the TeraStation on

.

Squeeze the left side of the front panel and pull the panel off.

DISK 1

DISK 2

DISK 2

DISK 1

ERROR

DISK 2

DISK 1