Buffalo TeraStation 1200 TS1200D0202-EU Ficha De Dados
Códigos do produto
TS1200D0202-EU
75
Notes:
• The USB memory device should have a capacity of at least 1 GB.
• Any data stored on the USB memory device will be deleted.
• The USB memory device should have a capacity of at least 1 GB.
• Any data stored on the USB memory device will be deleted.
2
In Settings, click Management
3
Click
to the right of "Restore/Erase".
4
From "Target USB drive", select the USB memory device that is connected to the USB 2.0 port of the
TeraStation.
TeraStation.
5
Select "Save current configuration to a USB drive". Click Execute.
6
The "Confirm Operation" screen will open. Enter the confirmation number, then click OK.
7
When the following message is displayed, saving settings is finished. Click OK.
Troubleshooting:
If the settings are not saved to the USB memory device successfully, you may receive the error message "The
specified operation cannot be executed". Verify:
• The device has a capacity of 1 GB or larger.
• The device is not write-protected.
specified operation cannot be executed". Verify:
• The device has a capacity of 1 GB or larger.
• The device is not write-protected.
Note: If you changed any hostname or network settings since your last backup, save your settings again to the
USB memory device again.
USB memory device again.
Applying Settings
The saved settings can be applied to a different TeraStation (of the same series). There are two ways to apply settings
from the USB memory device.
from the USB memory device.
Applying from Settings
1
Connect the USB memory device with the saved settings to a USB 2.0 port (not a USB 3.0 port) of the
TeraStation.
TeraStation.
2
In Settings, click Management.