Namae Electronics Pushbutton 12 Vdc 0.05 A 1 x Off/(On) JTP-1136 momentary 1 pc(s) JTP-1136 Ficha De Dados
Códigos do produto
JTP-1136
SPECIFICATION
PAGE
TACT SWITCH
1 / 4
1. GENERAL
1.1 Application : This specification is applied to low current circuit tactile switch
for electronic equipment.
1.2 Operating temperature range : -20 ~ 70℃, 45 ~ 85% RH
1.3 Storage temperature range : -30 ~ 80℃. However, 96 hours maximum for continuous
storage over a range -20 ~ -30℃ and a range 70 ~ 80℃.
1.4 Test conditions : The standard test conditions shall be 5 ~ 35℃ in temperature,
45 ~ 85% RH and 860 ~ 1060mbar in atmospheric pressure.
Should any doubt arise in judgement, tests shall be conducted
at 20±2℃, 65±5% RH and 860 ~ 1060mbar.
2. RATED VOLTAGE AND CURRENT.
DC 12V 50㎃
3. ELECTRICAL PERFORMANCE
TEST CONDITIONS
Contact
arrangement
Contact
Measured at DC 5V 100mA or by ohmmeter allowing
resistance
a small current at 1㎑ with a load of twice
of the Actuating force.
3.3
3.4
3.5
APPD
CHKD
DSGN
TITLE
DOCUMENT NO.
ZONE SYMB DATE APPD CHKD DSGD
3.1
3.2
* No insulation defect
shall be observed.
shall be observed.
* less than 5 msec.
* 1 pole, 1 throw.
Measured by lightly striking the center of the
button stem at a rate of 3 operations/sec…
button stem at a rate of 3 operations/sec…
Insulation
resistance
resistance
PROPERTY
DC 100V is applied between terminals and
between terminals and cover for 1minute
±5seconds.
between terminals and cover for 1minute
±5seconds.
AC 250V (50 ~ 60㎐)is applied between terminals
and between terminals and cover for 1 minute.
and between terminals and cover for 1 minute.
JT 0102LF
PERFORMANCE
* greater than 100㏁.
* less than 50mΩ.
Bounce
Dielectric
strength
strength
PDF created with pdfFactory Pro trial version