Graupner Hendheld RC 2.4 GHz No. of channels: 5 33110 Manual Do Utilizador

114 Program description: Telemetry menu

The menus grouped together under the overall heading 
“Telemetry” are called up with the optional available 
Smart-Box
Install the SMART-BOX at the mounting bracket of the 
transmitter fi gure. Connect the box then the 3-pin lead to 
the transmitter. Put one end of the cable into the DATA 
jack on the transmitter and the other into the jack on the 
right side of the SMART-BOX. The connector system is 
polarised, look for the small camfer on the edges. Never 
use force - the plug should engage easily and fully. The 
sockets are labeled accordingly: black wire (-), red wire 
(+) and orange wire (S).

Basic menu operation
In general terms the “Telemetry” menu is operated with 
the four buttons on the top of the Smart-Box. You can 
switch between the individual pages of the Telemetry 
menu using the 

 and 

 buttons: you will fi nd 

corresponding direction indicators at top right of every 
screen page in the form of angle brackets (< >); see 
illustrations. If only one angle bracket is visible, then you 
are currently at the fi rst or last page. In this case it is 
only possible to switch pages in the direction indicated 
by the angle bracket.
Menu lines in which parameters can be altered are 
marked with an angle bracket prefi x (>). Pressing the 
buttons 

 and 

 causes the “>” pointer to jump 

forward or back by one line. Lines to which you cannot 
jump contain no user-variable values.
If you wish to change a parameter, press the 

 

button simultanously to highlight the parameter (black 
background)). Change the value within the possible 
range using the 

 or 

 buttons, and then press the 

 button again briefl y to accept the value. Press 

the 

 button to return back to starting position.

MENU SETTING AND DATAVIEW

On the fi rst screen page of the sub-menu “Setting & 
Data View”, headed …

... only partially adjustments can be made. This page 
provides information to the general transmitter settings:

ACTION 
VOLT

Current operating 
voltage (V)

-

MAXIMUM 
VOLT

Maximum 
operating voltage 
(since the last 
power on - V)

-

MINIMUM 
VOLT

Minimum 
operating voltage 
(since the last 
power on - V)

-

ALARM 
VOLT

voltage setup for 
transmitter low 
voltage warning
beep

4 – 15 V in steps of 
0.1 V
Factory setting 
4.5 V

COUNTRY

Country setting

GENERAL / 
FRANCE

RANGE 
TEST

indicates if the 
range test is 
engaged, the 
remaining
time also appears

OFF / ON

Transmitter low-voltage warning (ALARM VOLT)
you can adjust the low voltage threshold at which the 
alarm (continuous beeping) is triggered; the available 
range is 4 - 15 V - factory default setting 4.5 Volt.
When the alarm is triggered, “VOLT-E” fl ashes at top 
right in the SMART-BOX transmitter display, and the 
parameters ACTION VOLT and ALARM VOLT are 
displayed in inverse form.

SETTING & DATA VIEW