Hgb Heat sealer with air exhaust Vacuumgerät 31348 Ficha De Dados
Códigos do produto
31348
4
A:
Power control lamp: The device is ready for use when this lamp is lit.
B:
ON / OFF switch: Press this button when the device is ready for use. The last sealing time set is
displayed, the ventilator starts and the machine is ready to vacuum. The machine can of course
also be switched off using the ON / OFF switch. You can disconnect the machine from the
power supply after switching it off.
displayed, the ventilator starts and the machine is ready to vacuum. The machine can of course
also be switched off using the ON / OFF switch. You can disconnect the machine from the
power supply after switching it off.
C:
Start button: When you press the start button, the vacuuming process starts followed by the
sealing process. This button should only be used for vacuuming bags or continuous rolls of
vacuuming sheeting. Place the bag with the open side in the middle of the area with the sealing
ring, then close the lid.
sealing process. This button should only be used for vacuuming bags or continuous rolls of
vacuuming sheeting. Place the bag with the open side in the middle of the area with the sealing
ring, then close the lid.
D:
Seal button: With this button you can interrupt the vacuuming process and seal the bag. This
makes sense if you want to seal goods that are easily crushed, so that they are not damaged.
makes sense if you want to seal goods that are easily crushed, so that they are not damaged.
E:
Digital display: 1. Shows the vacuum time in seconds and counts backwards to '0'.
2. Shows the sealing time in seconds. This value can be set from 0 – 5 seconds. This set time
will be saved for the next sealing process.
3. When the display shows "E" then the device is in protect status. Let the machine cool down
until it is ready for use again.
2. Shows the sealing time in seconds. This value can be set from 0 – 5 seconds. This set time
will be saved for the next sealing process.
3. When the display shows "E" then the device is in protect status. Let the machine cool down
until it is ready for use again.
F:
Set sealing time: Press the +/- buttons to adjust the time. If you select the value "" the machine
will not seal.
will not seal.
G:
Pulse button: The air will be pumped out for as long as you press the pulse button. That way
you can dose the suction strength for easily damaged goods.
you can dose the suction strength for easily damaged goods.
(Marinate/Canister) These buttons are not needed since these accessories are not include in
the scope of delivery and can also not be supplied later.
the scope of delivery and can also not be supplied later.
Safety notices: Please follow the following safety notices for your own safety:
•
•
Read the operating instructions carefully.
•
Do not use the vacuuming device on wet or hot surfaces or near heat sources.
•
Do not submerge the device or the supply cable in water or other liquids.
•
When you pull the plug out of the outlet, please do so by pulling the plug directly and not the
cable. Do not pull the cable.
cable. Do not pull the cable.
•
Only operate the device with a supply line that is in good order and condition. If it is damaged,
please replace it immediately.
please replace it immediately.
Maintenance
•
•
Disconnect the device from the power supply before cleaning the machine.
•
Use a mild detergent and a damp cloth to clean the device.
•
The sealing ring is removable so that you can clean the machine properly. Remove all spilled
liquids that have leaked while vacuuming from the vacuum chamber.
liquids that have leaked while vacuuming from the vacuum chamber.
Disposal:
Electronic devices are recycable materials and should not be disposed of with hou-
sehold waste. Dispose of the product at the end of its useful life according to the
applicable regulations.
Electronic devices are recycable materials and should not be disposed of with hou-
sehold waste. Dispose of the product at the end of its useful life according to the
applicable regulations.
Copyright by
www.berger-schroeter.de
All rights reserved. It is not permitted without written approval from Berger + Schröter to reproduce these operating instructions. It is
also not permitted to reproduce extracts in any form that have been created or processed by use of electronic, mechanical or chemical
procedures. Technical changes can be made at any time without prior announcement. The operating instructions are corrected regu-
larly. We assume no liability for technical and typographical errors and their results.
also not permitted to reproduce extracts in any form that have been created or processed by use of electronic, mechanical or chemical
procedures. Technical changes can be made at any time without prior announcement. The operating instructions are corrected regu-
larly. We assume no liability for technical and typographical errors and their results.