American Acoustic Development C Series-3G Manual Do Utilizador

1-10

pressure wave. You can use this position if you are unable to get a good 
integration between the subwoofer and main speakers.

       At “off” position, the amplifier will function normally without the effect of the           

5-band equalizer.

         Please refer to “Setting up EQ for the Room”

High Level Inputs L&R
These inputs should be connected to the left and right speaker terminals of your 
amplifier/receiver, if you intend to connect the subwoofer using this option 
instead of the low-level RCA input connections.

High Level Output L&R
You could connect your main speakers from the subwoofer amplifier instead of 
the main amplifier/receiver. Use this option if you are connecting the 
subwoofer up via the High Level Input.       

CAUTION! Do not use both low level and high level connection methods 
simultaneously. This may cause damage to the subwoofer and your 
amplifier/receiver.

  Low level Input & Output 

Connect this to the pre-amp output of your amplifier/receiver. If you do not 
have a pre-amp output or a power amplifier input, you can connect up the 
subwoofer using the Low Level Input/Output utilizing a tape input/output 
amplifier/receiver. Connect the tape output to the Low Level Input on the 
subwoofer, then connect the tape input to the Low Level Output on the 
Subwoofer. To switch the subwoofer into the circuit, switch the tape monitor 
input on your amplifier/receiver.

Use this in conjunction with your receiver/amplifier. Connect this output to the 
power amplifier input of your amplifier/receiver.

For continued protection, replace only with same type fuse. (A spare fuse is 
enclosed for replacement.)

8

8