American Acoustic Development C Series-3G Manual Do Utilizador

Depending on the shape of your room (etc.), you may wish to place the rear speakers 

behind you instead of on the side walls. In this case, you can use a pair of large floor 

standing speakers matching your front speakers. 

Note: Make sure your amplifier is off and disconnected from power while you are 

connecting speakers to amplifier. Turn your amplifier on only after you check and 

make sure speakers are properly connected. 

Connections are made at the terminals located on the back of the loudspeaker system. 

The terminals accept spade plugs, bare wire or banana plugs. For best results, use high 

quality speaker cables.

All C Series-3G loudspeakers have 4 gold plated binding post for single or bi-wring 

options.

 

This method uses only one pair of cables to connect each speaker to the amplifier. (see 

Fig. 1).

For each channel, the red terminal on the loudspeaker should be connected to the red 

or (+) loudspeaker connection terminal on the receiver or amplifier. The black
terminal on the loudspeaker should be connected to the black or (-) loudspeaker 

connection terminal on the receiver or amplifier. Connecting the loudspeakers in this 

manner ensures that they will be in phase; that is work together rather than in 

opposition.  Connecting the loudspeakers out of phase will not damage them, but will

result in less bass and poor imaging.