Konexx Office Konnector Manual Do Utilizador

hapter 1 describes the items you should have received with your KONEXX Office  Konnector and any additional items you

may need.

When you unpack your components, make sure you have all of the following items and that none of the items is damaged:

♦

  One KONEXX Office  Konnector.

 

♦

  One AC adapter.

If any items are missing or damaged, contact your place of purchase immediately.

Before installing your KONEXX Office  Konnector , observe the following guidelines:

DIALING
Configure your modem, fax/modem, or fax machine for Tone dialing

.

SPEAKER PHONES
If the attached telephone has speakerphone capability, disable speakerphone operation. This mode deactivates the handset
jack used to send and receive data.

TELEPHONE LEVEL SWITCH
Set the Telephone Level switch for the telephone you are using (refer to Chapter 3).

SPEAKER CONTROL AND VOLUME
The telephone handset is deactivated during dialing.
If you use a modem or fax/modem, you can use the command to enable the modem speaker and the command to set its
volume. You can then "listen in" on dialed calls to monitor their status. Refer to your modem manual for information.

hapter 2 describes installation procedures for your KONEXX Office  Konnector.

To connect your KONEXX Office  Konnector to a telephone (refer to figure 2.1, page 5):

1.  Remove the spiral handset cord from the telephone  handset jack on the telephone base  unit and insert it into the

KONEXX Office  Konnector jack  labeled HAND SET.

 
2.  Insert the KONEXX Office  Konnector modular telephone cord (which is permanently attached at one end to the KONEXX)

into the telephone handset jack on the telephone base unit.