Vivid Audio V1p Manual Do Utilizador

 

The mounting stalk is screwed 
directly onto the exposed m8 
thread and is used to secure the 
whole sub assembly to the wall 
(use a 13mm spanner not 
provided). 
 
In order to obtain the maximum 
benefit from your purchase, it is 
important to know something about 
the acoustics of the room in which 
you intend to install the 
loudspeakers. No matter how well 
the product performs in a good 
environment, the performance will 
be adversely influenced if care is 
not taken at this stage. Extensive 
information of room acoustics is 
available to you on our web site 

www.vividaudio.com

 

  
This procedure applies to V1p due 
to physical constraints on the use 
of V1w. 
 
A précis of this guideline follows: 
 

All connections/reconnections must 
be made when the amplifier is 
switched off. 

 
Start with the two main front 
speakers. Position the left front 
speaker one fifth of the width of the 
room from the left hand wall and 
one third of the distance from the 
back wall. Connect the low 
frequency (LF) terminals of the 
loudspeaker ONLY (facing the back 
of the loudspeaker, the LF 
terminals are on your left). We 
suggest you now load some well 
known music with predictable lower 
octave musical content into the CD 
player. A listener should be seated 
in the listening position and listen to 

subtle changes in bass character 
and cleanliness whilst the speaker 
is moved in the longitudinal plane 
towards and away from the rear 
wall of the room. A point will be 
reached where the bass sounds 
clean and believable. Mark this 
distance from the rear wall. Do the 
same in the lateral place about the 
position just realised. An improved 
result should be obtained. DEAD 
EASY! You have found the optimal 
position for the low frequency 
portion of the audio band in your 
room. 
Place the right hand speaker in the 
mirror position on the right hand 
side of the room. From the seated 
position you should be equidistant 
from each speaker. We suggest 
you toe the speakers in towards the 
listening position so that the 
visually extended centres of the 
tweeters cross some way in front of 
you in the listening position.  This 
may be re-adjusted once the 
loudspeakers are settled in. 
 
Use a well-known piece of music. 
At this stage you should mark and 
note the position you have found. 
After listening to this track and a 
few others you may find that 
moving the speaker forward 
(towards the listening position), 
improves the sound stage. This is a 
personal preference and is worth 
spending time on.  
 
 

 
Connect the right red terminal of 
your amplifier to the red terminals 
of your right hand loudspeaker. The 
black terminal of your amplifier is 
connected to your right hand 
loudspeaker’s black terminals  

 

4